Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Extracted text for finding words
This extraction supports search. Read the original page for complete notation and layout.
2/27/2014 AC 27-1B, Chg 4
the rotorcraft environment and anticipated installation location, such as cockpit or
avionics bay. Similar decisions must be made for other tests, such as temperature and
electromagnetic interference (EMI) susceptibility. If the TSO environmental
considerations do not adequately represent the actual installation environment, the
differences must be considered and evaluated, and a course of action must be taken to
correct deficiencies. Procedures provided by AC 27-1, section 27.1309, associated with
temperature testing, should be followed to determine whether the equipment design is
appropriate for the specific installation environment.
(6) System Performance Validation. The applicant should demonstrate that the
performance of the HTAWS, with regard to the position of the rotorcraft relative to the
terrain or obstacle, is adequate to prevent hazardously misleading information. The
integrity of the navigation source has a significant effect on acceptable performance of
the system. The applicant should demonstrate that the performance of the HTAWS is
suitable for each phase of flight (en route, terminal, approach, and low altitude mode)
for which approval is sought. Flight evaluations are normally required to assess reduced
protection modes, operation in the vicinity of airfields, operations into and out of
unimproved landing zones and off-airfield operations (helipads or other destinations not
coded into the HTAWS database as aerodrome or helipad). HTAWS status and mode
configuration should be easily seen. Mode selection (e.g., inhibit, reduced protection)
should be easily accomplished without undue concentration on the pilot’s part. All
visual indications should be readable in all lighting conditions. Refer to RTCA DO-309,
paragraph 3.4, Test Procedures for Installed Equipment Performance, for more
information.
h. Installation Considerations.
(1) Selecting a display where multiple functions are presented. In these cases, a
means to select or de-select the display of terrain and obstacle information should be
provided. However, the means to select or deselect the display should not void or alter
terrain and obstacle aural alerts. Care should be exercised in selecting a multifunction
implementation, to ensure that the display sharing is appropriate for the specific
functions. The use of the HTAWS display should not unacceptably detract from the
usability of required functions that share the display with HTAWS. Since the HTAWS
display is not to be used for navigation, the use of the display should not impair the
ability of the pilot to perform required navigation functions. An example of such
impairment would be an installation that forces the pilot to choose between the HTAWS
display and the needed navigation information in situations where both could be
effectively used simultaneously and continuously (e.g., instrument approach in the
vicinity of hazardous terrain and obstacles). If the timesharing of the display between
HTAWS and other functions is deemed acceptable, the design should facilitate simple
switching between the functions, with minimal time delays, so both functions are
sufficiently accessible in realistic flight scenarios.
(2) Locate visual alerts in the pilot’s primary field of view. HTAWS status and
mode selection annunciation (i.e., inhibit, reduced protection mode, or other pilot
Page MG 18 - 9