FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page F-30.1

PDF page 591 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 591
AC 27-1B · F-30.1Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

6/23/23                                        AC 27-1B, Chg 9

AC 27.1309B. § 27.1309 (AMENDMENT 27-51) EQUIPMENT, SYSTEMS, AND
INSTALLATIONS.


    a. Explanation. Amendment 27-51 revised § 27.1309 to address advances in
technology and eliminate the distinction between multi-engine and single-engine
rotorcraft. The rule now includes the same language as § 29.1309. The rule also:


         Revised § 27.1309 (a) to clarify the requirements for performing a failure
          analysis.
         Replaced § 27.1309 (b) and (c) with language consistent with contemporary
          industry practices.


    b. Types of Equipment. Section 27.1309 covers, but is not limited to, electrical,
pneumatic, and hydraulic power sources, distribution, and corresponding utilization
systems.


       (1) Applicability. Section 27.1309 is intended as a general requirement that is
applicable to any equipment or system as installed, in addition to specific systems
requirements, except as indicated below.


                  (i) General. If a specific part 27 requirement predefines systems safety
aspects (e.g., redundancy level or criticality) for a specific type of equipment, system, or
installation, then the specific part 27 requirement will take precedence. This precedence
does not preclude accomplishment of a system safety assessment, if necessary. For
example, § 27.695 predefines a required level of redundancy and an implied level of
system reliability. However, a system safety assessment approach may still be required
to show that the implied system reliability is met and to address assessment of the
failure modes.

                  (ii) Section 27, Subparts B, C, and D. Section 27.1309 does not apply to the
design features required by Subparts B, C, and D of part 27 for aspects such as the
performance, flight characteristics, structural loads, and structural strength. However,
the requirements in § 27.1309 do apply to any equipment and system that the proposed
design uses to comply with the requirements of Subparts B, C, and D (e.g., Health
Usage Monitoring System certified for maintenance credit and Stability Augmentation
System).

                  (iii) Section 27, Subpart E.




                          Page F - 30.1

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →