Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B, Chg 7 2/4/2016
2.3 Additional Required Equipment Functioning Correctly for NVG Operations (define this for each
helicopter).
2.3.1 Vertical speed indicator or equivalent.
2.3.2 List other aircraft equipment identified in the STC required for the operation like curtains
separating the cockpit from the passenger cabin, chin bubble mats, etc.
2.3.3 If a design method (e.g., chin mats) is used to block the light from entering the cockpit, a
caution such as the one below may be required. Only add requirements for chin mats or
other light blocking items, like curtains, if they are required by the STC. Do not add generic
statements or “if needed” statements to the limitations section of the RFMS.
“CAUTION:
Ensure <enter chin mats, or whatever is used to block chin bubble light> are positioned and secured
properly, allow sufficient view out of the chin bubble, and that they do not block or restrict operation of the
flight controls.”
2.4 Minimum Crew. For foreign certifications, check with the foreign authority for correct wording.
2.4.1 Additional crewmember use of NVGs during single-pilot operations into and out of
unimproved sites:
2.4.1.1 Landing. An additional NVG trained crewmember must be equipped with and use NVGs
during landing to assist in obstacle identification and clearing.
2.4.1.2 Takeoff. An additional NVG trained crewmember must use NVGs during takeoff from
unimproved sites to assist in obstacle identification and clearance if operational
conditions permit (i.e., patient status allows).
2.5 Incompatible NVIS Lights. Specifically identify installed lighting in the cockpit and cabin that the STC
did not modify and that are not useable during NVG operations. Additionally, include instructions on the
use of non-NVIS lighting modified carry on equipment (e.g., cell phones, mission equipment, medical
equipment) during NVG operations. For example, instructions should be the following or similar:
“Use of non-NVIS modified carry-on or personal equipment in the cockpit is prohibited
during NVG operations.”
The pilot must coordinate with other crewmembers and passengers before the use of
non-NVIS modified carry-on equipment is used during NVG operations.
3. EMERGENCY AND MALFUNCTION PROCEDURES.
3.1 NVG Malfunction or Failure. Describe procedures for NVG failure and for transition from aided to
unaided flight, as may be required.
3.2 NVIS Lighting Malfunction or Failure in Flight. Describe procedures for handling NVIS lighting
malfunctions, including procedures if the malfunction or failure degrades NVIS compatibility.
4. NORMAL PROCEDURES. Provide configuration and check procedures to ensure aircraft is
capable of NVG operations. Suggested procedures are:
4.1 Operational Procedures.
4.1.1 Preflight.
Page MG 16-14
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.