Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B, Chg 7 2/4/2016
will be used for the NVIS evaluation should be flown to familiarize the test pilots with possible hazards in
the test area.
(C) Installing dual controls for every flight test evaluation is recommended, as additional
risk-mitigation procedures may be required to conduct the test safely. If it is determined that the normal
configuration of the aircraft is required for the flight evaluation, it may not be possible to install dual
controls (such as, for example, in a police helicopter where the second crew station is equipped with
comprehensive police mission systems). In this case, appropriate training and authorization may be
required for the FAA test pilot to conduct the in-flight evaluation. The occupant of the second crew
position should be a pilot trained in the use of NVGs and familiar with the installation under evaluation. In
addition, special test equipment may be installed during the evaluation to enhance flight test safety.
Minimum crew should be used to conduct an evaluation. If additional personnel are required for the
evaluation, install the appropriate crew stations and safety equipment.
(D) The flight test profile should consist of maneuvers representative of those performed
during normal or special operations over terrain and cultural areas in various illumination and weather
conditions. This test should include evaluation under low illumination conditions (e.g., no moon, and
overcast sky, with little cultural lighting). RTCA Document DO-275, section 4.4.2 provides one acceptable
test procedure and test sequence. Alternatively, as a minimum, complete the NVIS-NVG Compatibility
Flight Evaluation found at http://www.faa.gov/aircraft/air_cert/design_approvals/rotorcraft/nvis.
g. Rotorcraft Flight Manual (RFM) (or Supplement (RFMS)).
An RFMS template is provided on the following pages.
Page MG 16-12
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.