Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Extracted text for finding words
This extraction supports search. Read the original page for complete notation and layout.
4/25/06 AC 27-1B, Chg 2
Also, approval and proper usage should be continuously maintained during the entire
procurement and manufacturing cycles.
(v) Alternate fabrication and process techniques should be approved and
must comply with § 27.605. Any alternate techniques should provide at least the same
level of quality and safety as the original technique. Any changes should be presented
and FAA/AUTHORITY-approved well in advance of the change’s production effectivity.
(2) The second area is the basic raw constituent, pre-preg, and laminate
material acceptance requirements and material property determination requirements of
§§ 27.603 and 27.613. These criteria require application of the critical environmental
limits such as temperature, humidity, and exposure to aircraft fluids (such as fuel, oils,
and hydraulic fluids), to determine their effect on the performance of each composite
material system. Temperature and humidity effects are commonly considered by
coupon and component tests utilizing preconditioned test specimens for each material
system selected. Material “A” and “B” basis allowable strength values and other basic
material properties (based on MIL-HDBK-17 or equivalent) are typically determined by
small-scale tests, such as coupon tests, for use in certification work. In the case of
composites, determination of these basic constituent and material system properties will
almost invariably involve the submittal, acceptance, and use of company standards.
Although MIL-HDBK-17 does have some "B" basis allowables available in Volume 2,
company testing is required for "A" basis and other "B" basis material systems not
listed. Also, test methods vary somewhat from manufacturer to manufacturer;
therefore, individual company results will exhibit some scatter in final material property
values. Any company standard that is approved and used should meet or exceed
related MIL-HDBK-17 requirements. Material structural acceptance criteria and
property determination should, as a minimum, include the following:
(i) Property characterization requirements of all material systems (e.g.,
pre-pregs, adhesives, etc.) and constituents (e.g., fibers, resins, etc.) should be
identified, documented, and approved. These requirements, once approved, should be
placed in all appropriate procedures and specifications (such as those in
paragraph (g)(1) above).
(ii) Moisture conditioning of test coupons, parts, subassemblies, or
assemblies should be accomplished in accordance with MIL-HDBK-17, other similar
approved methods, or per FAA/AUTHORITY-approved programs.
(iii) The maximum and minimum temperatures expected in service (as
derived from test measurements, thermal analyses on panels and other parts,
experience, or a combination) should be determined and accounted for in static and
fatigue strength (including damage tolerance) substantiation programs considering
associated humidity-induced effects.
(iv) The glass transition temperature, Tg, is an important characteristic
parameter of amorphous polymers, such as epoxies. It is the temperature below which
Page MG 8 - 11