Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B, Chg 4 2/27/2014
*(13) FDMS. If required under an operating regulation, an FDMS (not to be
confused with a flight data recorder (FDR) certificated under § 27.1459) may be
comprised of a system or combination of systems that record a helicopter’s flight
performance and operational data. An FDR certificated under § 27.1459 and the
appropriate operating rules would be acceptable to meet this requirement; however, an
FDMS would not be adequate to meet the § 27.1459 requirement for an FDR. The
FDMS should record digital or analog raw data, images, cockpit voice or ambient audio
recordings, or any combinations thereof, according to a broadly defined set of
parameters including information pertaining to the aircraft’s state, condition, and system
performance. This data can be used to perform post flight analysis and provide critical
information to investigators in the event of an incident or accident as well as to promote
operational safety. When used in conjunction with an FAA-approved flight operations
quality assurance (FOQA) program, part 135 certificate holders would be required to
collect flight performance and operational data that characterizes the state of the
helicopter and its subsystems that the certificate holder determines is pertinent to its
safety program. FDMS data should be recorded and stored on digital media, and when
selecting a location to install the hardware device used for storing the data,
consideration should be given to the potential for survival in the event of a crash. The
system should receive electrical power from the helicopter’s bus that provides the
maximum reliability without jeopardizing service to essential or emergency loads, and
capable of being operated continuously from the time power is applied to the aircraft
until power is removed from the aircraft.
(i) Safety. The FDMS equipment should not, under normal or fault conditions,
adversely affect the airworthiness of the systems to which it is interfaced or of other
aircraft systems. The equipment should be installed in accordance with all applicable
safety regulations. The equipment should be tested under the standards of RTCA
DO-160F, "Environmental Conditions and Test Procedures for Airborne Equipment," or
subsequent issue. The European Organization for Civil Aviation Equipment
(EUROCAE) specification ED-14 may be used in lieu of RTCA DO-160. Additional
crashworthiness testing may be conducted according to EUROCAE specification
ED-155, “Minimum Operational Performance Specification for Lightweight Flight
Recording Systems.” Equipment testing should be conducted to the categories most
applicable to the aircraft type, and the location of the equipment to be installed. The
equipment manufacturer typically defines the test class within each environmental
category. The objective of this level of testing is to ensure that the equipment does not
present a hazard to the aircraft, and can survive and continue to operate under the
environmental conditions to which it will be subjected throughout its life. Specific testing
may be required to demonstrate that the equipment performs its intended function when
operated over the full environmental conditions to which it has been declared to comply.
Consideration should be given to the extremes at which it may be subjected during an
incident or accident. These tests can be undertaken during the specified RTCA DO
160F (or later revision) tests or separately. Analysis may be substituted for a test where
its use can be shown to produce equivalent evidence of compliance. The system
should be capable of recording up to 2 hours of image or acoustical data and 6 hours of
Page MG 6 - 16
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.