Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B, Chg 7 2/4/2016
b. Test Procedures. Where the airworthiness or operating regulations require a
system to perform its intended function, and not create a hazard to other required
systems, accomplish sufficient testing to ensure satisfactory performance. When
ground testing is not sufficient to evaluate a system’s performance properly, accomplish
flight testing. Acceptable flight test criteria for specific navigation and communication
equipment are contained herein. If seeking IFR operations approval for the rotorcraft,
satisfy the additional criteria of section AC 27 Appendix B of this AC.
(1) VHF Systems.
(i) General. Provide intelligible communications between the rotorcraft and
ground facilities throughout the airspace within 80 nautical miles (NM) of an
FAA/AUTHORITY ground facility from radio line of sight altitude to the maximum altitude
for which the rotorcraft is certificated. Provide communication with the rotorcraft at or
above line of sight altitude in right and left bank up to 10° and on all headings.
(ii) Electromagnetic Compatibility (EMC). With all systems operating in flight,
verify by observation that no adverse effects are present in the flight systems.
Complete a qualitative evaluation of VHF radio navigation and communication
equipment operation. Further guidance may be found in AC 43.13-2B, Chapter 2,
paragraph 209.
(iii) Antenna Measurement. If provided satisfactory antenna measurement
data, reduce the following flight test to checks in right and left turns near the predicted
bearings of worst performance. If antenna locations are symmetrical, conduct tests
using only one turn direction.
(A) Long range reception. Starting at a distance of 80 NM from the ground
facility antenna, perform a right or left 360° turn at a bank angle of at least 10°.
Communicate with the ground facility every 10° of turn to test the intelligibility of the
signals received at the ground station and in the rotorcraft. For 80 NM, the minimum
line of sight altitude is approximately 4,000 feet.
(B) Approach configuration. With the landing gear down and with the
rotorcraft in the approach configuration (at a distance of 10 NM from the ground station
and in an idle power descent toward the station), demonstrate intelligible
communications between the rotorcraft and the ground facility.
(2) HF Systems.
(i) Demonstrate acceptable communications by contacting a ground facility at
a distance of at least 80 NM. Single sideband equipment should also perform
acceptably in the amplitude modulation mode of operation.
Page MG 1 -4
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.