Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B 9/30/99
(2) Cockpit Area Microphone (CAM). The third channel of recorded information
is specified to be from a cockpit area microphone or from voice activated lip
microphones at the first and second pilot stations. It should be noted that a
continuously recording or “hot” microphone at both the first and second pilot stations
would satisfy this CAM requirement. Due to the ambient noise level in rotorcraft, the
use of “hot” microphone results in objectionable constant hissing in the pilot’s headsets.
Therefore, it is recommended that “hot” microphones not be used on rotorcraft.
(3) CVR Mechanical Installation. The CVR or the portion thereof which
contains the recording should be physically located to enhance the probability of the
recording surviving a crash. Normally, such a location would be in the lower portion of
the rotorcraft as far aft as possible.
(4) Intelligibility of Recordings. Tests should be accomplished to determine that
the recording is intelligible enough to make a positive identification of the speaker and
the words or phrases spoken. This is usually accomplished by flight operations to
produce the maximum cockpit background noise. The operation should provide for the
normal speech of all crew members to be recorded on the pertinent channels. Then,
during playback, preferably using a different listener, the listener should be able to
identify the different crew members, the words and phrases spoken by the crew, and
the radio communications made by and to the crew. The use of special filters and
multiple playbacks to improve intelligibility is acceptable.
(5) Electrical Power Supply. The rule requires that the CVR should be supplied
with power from the most reliable source that does not jeopardize essential or
emergency loads. Since the functioning of the CVR is required by operating rules for
some operations, it should be given priority over other nonessential loads.
(6) Self-Test Function. The CVR should be provided with a means in the
cockpit that will allow a test to ensure the CVR is functioning properly. This may be
accomplished by a manual playback feature.
(7) Bulk erasure. If this function is provided, the installation should be as
follows:
(i) Any probable malfunction will not cause erasure of the recording
medium.
(ii) The crash impact forces will not cause activation of the bulk erasure
function.
(iii) Inadvertent actuation of the bulk erasure function is minimized.
Usually, this is accomplished by requiring two separate actions to operate the bulk
erasure.
Page F - 100
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.