Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B, Chg 1 2/12/03
while performing their normal duties. The IIDSS display must also meet the applicable
requirements of § 27.1322. Fixed probes must be located in areas easily scanned by
the crew, and must be visible under normal daytime and nighttime flying conditions.
(B) Icing conditions can exist when visible moisture in any form is
present and the Outside Air Temperature (OAT) is 41ºF (or 5° Celsius) or lower or the
Total Air Temperature (TAT) is 50ºF or lower. It should be noted that icing conditions
may also exist when the OAT is 50ºF (10°C) or lower while operating on the ground
where surface snow, water, slush, etc., may be ingested by engines or freeze on
engines, nacelles, engine sensor probes, rotors, or other critical surfaces.
(C) The core of any IIDSS is the ice detector device and its location.
Ice detectors should be installed in carefully determined locations to avoid interference
from air data sensors, external protuberances (including aircraft options such as rescue
hoists, flotation devices, and radar units), rotor downwash induced water impingement,
wheel splash during ground operation, etc.
(D) From the standpoint of powerplant icing protection, airframe
visual icing cues are not an acceptable means to advise the flight crew to activate the
engine ice protection system. Delaying the use of the engine ice protection system until
ice build-up is visible from the cockpit may result in severe engine damage and/or
flameout due to shed ice ingestion, and is therefore unacceptable. The engine ice
protection system is to be activated by the flight crew in accordance with approved
Rotorcraft Flight Manual (RFM) procedures when icing conditions exist, if using an
advisory system, or automatically if using a primary system. Current engine induction
ice protection systems are operated as anti-ice systems, as required by the RFM
limitations and procedures. These requirements provide the necessary margin between
system activation and the ambient conditions. In-service experience has shown that
adherence to these RFM limitations and procedures has provided satisfactory engine
operation.
(E) An IIDSS that is intended as the prime means of alerting the
flight crew or operating the de-icing/anti-icing systems should contain certain features:
(1) An IIDSS system hazard analysis should be completed in order
to choose the IIDSS architecture.
(2) The effectiveness of the IIDSS must be demonstrated during the
icing flight tests of §§ 27.1093 and 27.1419.
(3) The threshold level chosen to activate the ice detection and
annunciation system should be guided by:
(i) The assurance that when the amount of ice that is accreted on
the critical surfaces is shed, there will be no damage to the helicopter or engines, and
Page F - 84
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.