FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page F-74

PDF page 683 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 683
AC 27-1B · F-74Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

AC 27-1B                                                                  9/30/99


         (3) The use or application of the belts shall be proven in compliance with the
standard. The belt rated strength shall not be exceeded by the ultimate load derived
from § 27.561(b).

         (4) The rated strength of each unique belt may be stated in structural loads or
design criteria report and the corresponding maximum ultimate design load listed for
ease of comparison.

AC 27.1415 § 27.1415 (Amendment 27-11) DITCHING EQUIPMENT.

     a. Explanation.

         (1) Emergency flotation and signaling equipment is not required for all rotorcraft
overwater operations. However, if such equipment is required by an operating rule
(e.g., § 135.167), the equipment supplied for compliance with the operating rule must
meet the requirements of this section.

         (2) Compliance with the provisions of § 27.801 for rotorcraft ditching requires
compliance with the safety equipment stowage requirements and ditching equipment
requirements of §§ 27.1411 and 27.1415, respectively.

                  (i)   Emergency flotation and signaling equipment installed to complete
certification for ditching or required by any operating rule must be compatible with the
basic rotorcraft configuration presented for ditching certification.  It is satisfactory if
operating equipment is not incorporated at the time of original type certification of the
rotorcraft provided suitable information is included in the “Limitations” section of the
Rotorcraft Flight Manual to identify the extent of ditching certification not yet completed.

                   (ii)  When the ditching equipment required by § 27.1415 is being installed
by a person other than the applicant who provided the rotorcraft flotation system and
ditching emergency exits, special care must be taken to avoid degrading the functioning
of the aircraft devices and to make the ditching equipment compatible with them. (See
paragraphs AC 27.801a(9) and AC 27.1411a(2).)

     b. Procedures.

         (1) Liferafts and life preservers used to show compliance with the ditching
requirements must be of an approved type. Compliance with the requirements of
TSO-C12 for liferafts and TSO-C13 for life preservers will satisfy regulatory
requirements for approval of this equipment.

                  (i)    Life Preservers.





Page F - 74

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →