FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page F-62.11

PDF page 669 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 669
AC 27-1B · F-62.11Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

6/23/23                                          AC 27-1B, Chg 9


                           vii. MOC for Objective 9: Objective 9 specifies flight crew alerting if the
    failure of a battery installation, in itself or in relation to a system that performs an
    aircraft-level function, could result in “unsafe system operating conditions.” The alert
   should comply with the applicable color requirements in § 27.1322. The applicant
   should refer to Section AC 27.1322 for an acceptable method of compliance.

                            viii. MOC for Objective 10: The following are examples of “means” for
    flight crew or maintenance personnel to determine the battery charge state:


                        (a) A manually activated system (e.g., push button) that displays the
   available charge of each battery unit.

                         (b) An automatic system that records the available charge of each
   battery unit on an appropriate interval and makes it available to maintenance personnel
   before the next flight.

                          (c) Physical access that allows a maintenance person to measure
   the battery charge state.


              3. The MOCs for Objectives 1 through 10 are only acceptable for required
   functions if ICAs include a check of the battery charge state within an interval that will
   ensure sufficient charge for each flight considering the worst case scenario and
   replacement of the battery when the charge is not sufficient.

              4. MOC for Very Small Non-Rechargeable Lithium Batteries:

  An acceptable MOC for Objectives 1 through 8 for non-rechargeable lithium battery
   installations that have less than 2 watt-hours of energy is showing these batteries meet
   Underwriters Laboratories (UL) 1642 or UL 2054.


                     (ix)    Part 27 Compliance. Non-rechargeable lithium battery installations
   should satisfy each of the MOCs identified in this guidance to comply with all applicable
   part 27 requirements. The following provides means of compliance and other
   information on some part 27 requirements:


                (A) System Safety Assessment. Although these hazard conditions require
   specific functionalities and capabilities and address certain critical failure modes of non-
   rechargeable lithium batteries and their installations, the applicant must also meet the
   requirements of § § 27.1301 and 27.1309. To date, in-service experience has shown
   that non-rechargeable lithium battery thermal/pressure runaway conditions are not
   extremely improbable. Assume such failures could occur sometime during the life of the
   battery installation when demonstrating compliance with § 27.1309. Application of


                               Page F - 62.11

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →