Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
6/23/23 AC 27-1B, Chg 9
engine data when engine limiting factors are different (Engine 1 Torque, Engine 2 Gas
Temperature Indicator). See §§ 27.1321 and 27.1549.
(3) Engine design features or characteristics that forewarn the crew prior to the
parameter reaching the operating limit (the redline) should be evaluated.
(4) The SPI display must provide a timing countdown when operating with time
limited power settings and as required by § 27.1305(t).
(5) The minimum and maximum operating limits must be marked as required by
§ 27.1549.
(6) The SPI display should allow the pilot to identify indicator failures, engine
failures, partial power loss conditions, and adverse trends, to meet the requirements in
§§ 27.771(a), 27.1309, 27.1321, and 27.1549. The SPI design should also address all
normal and abnormal operations including start/shutdown and OEI conditions per
§ 27.771(a).
(7) Since the SPI is a system comprised of instruments required by subchapter C
of Title 14, its hazards are among those that must be assessed under the requirements
of § 27.1309. When conducting this assessment, to meet the requirements in
§ 27.1301, the applicant must take into account that the crew will operate the Rotorcraft,
monitoring the engine status and health, without continuously accessing the powerplant
display page. In addition, the assessment should assume the SPI will remain the only
engine instrument available in case of loss of one display.
Page F - 11.2
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.