FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page F-6

PDF page 564 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 564
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

AC 27-1B, Chg 1                                                           2/12/03

guidelines may be used to aid in determining when an in-flight temperature survey is
warranted.

               (a) Components that contain a CRT, LCD, etc., require the temperature
survey outlined in paragraph AC 2 7.1303b(4)(ii)(B)(4)(ii).

               (b) Equipment which does not contain a CRT, LCD, etc., but is specified
by the manufacturer to require forced air cooling (by an airframe-mounted system),
usually requires a temperature survey.

               (c) Equipment which does not contain a CRT, LCD, etc., and is not
specified as requiring forced air cooling may usually have its critical thermal
environment substantiated by laboratory testing.

                      (ii) Temperature Survey Testing. The temperature tests for the EFIS
units should consist of a short-term test of approximately 30 minutes which accounts for
an aircraft which has heat-soaked on the ramp. A factor of 25° F should be added to
the maximum corrected temperature to account for “greenhouse effect.” A long-term
test should be accomplished at various altitudes and limiting (low and high) airspeeds.
All avionics equipment should be turned on during this test, and the cockpit panel lights
should be operated at full intensity. The environmental control unit (ECU) or air
conditioning system should not be operating during these tests; however, any windows
or vents which are part of the “basic” TC rotorcraft may be utilized to ventilate the pilot’s
stations. Both these tests should be corrected to the maximum temperature for which
the rotorcraft is certified and a standard lapse rate for altitude as specified in this AC.  If
an airframe cooling system is necessary to keep the display units within acceptable
temperature limits, then the pilot(s) must be made aware of a failure or malfunction of
this cooling system. Some type of cockpit visual annunciation with the capability to
perform a preflight test is usually utilized to fulfill this requirement.

               (5) System Reliability.

                    (i)  Failure of the EFIS to perform an intended function which results in
the reversion to standby instruments or requires the use of abnormal procedures should
be shown to be improbable.

                      (ii)  For IFR operations, Appendix B of Part 27, paragraph VIII(b)(5)(iii),
requires that the equipment, systems, and installations must be designed so that one
display of the information essential to the safety of flight which is provided by the
instruments will remain available to a pilot, without additional crewmember action, after
any single failure or combination of failures that is not shown to be extremely
improbable. The display of attitude, altitude, or airspeed is individually “essential to the
safety of flight,” and, therefore, the loss of all attitude display, all airspeed information, or
all altitude information to the pilot(s) should be extremely improbable. Also, any
malfunction or failure of the EFIS which would result in the simultaneous incorrect
display of this critical information should be extremely improbable. In view of the


Page F - 6

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →