FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page E-116

PDF page 536 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 536
AC 27-1B · E-116Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

AC 27-1B                                                                  9/30/99

         (3) For compliance with § 27.1123(c), the piping and its restraint system should
be designed to minimize loading induced on the piping by the relative motion (in-service
deflections) of the components to which the system attaches. Isolation of significant
deflection induced loading (if required based on analysis and strain surveys) by use of
flexible joints or other equivalent devices or designs should be considered. Any such
in-line device used to reduce deflection loading should be fireproof and leak free when
performing its intended function.

         (4) For critical load case determination, the expansion induced thermal loading
should be added in with mechanical relative motion induced loads and internal exhaust
gas flow loads to provide total critical load for both a proper static and a proper fatigue
structural substantiation. The critical combined static load should be compared with the
emergency impact loads of § 29.561(paragraph b(2)) to determine the critical design
load case for static strength substantiation.

         (5) It should be noted that the majority of the exhaust piping verification testing
required for certification can be accomplished during the rotor drive system tie down
testing of § 27.923.





Page E - 116

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →