Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
3/31/2014 AC 27-1B, Chg 4
measured visibility to snow concentration is V = 374.9/C0.7734 where C is the snow
concentration (grams/meter3) and V is the visibility (meters).
(A) This equation can be reasonably applied to all snowflake type
classifications and is credited to J.R. Stallabrass, National Research Council of Canada.
(B) Other equations may be applied if they are shown to be accurate for
the particular snowflake types for the test program.
(v) The snow concentration corresponding to the ¼-mile or less visibility
prescribed will be extremely difficult to locate in nature. Data from Ottawa, Canada,
research indicate that fewer than 4 percent of the snowstorms encountered there meet
the 0.91 grams/m3 concentration associated with the ¼-mile visibility. Furthermore, the
likelihood that the desired concentration will exist for the duration of the testing is even
more remote. Because of these testing realities, it is very likely that exact target test
conditions will not be achieved. Those involved in certification must exercise good
judgment in accepting alternate approaches.
(vi) For some engine induction systems, it may become apparent by
inspecting for moisture accumulations that ground and IGE hover operations in
recirculating snow are much more severe than the level flight test. In this instance, it is
reasonable to accept prolonged IGE operations in recirculating snow and to accept
durations of less than 1-hour level flight in ¼-mile or less visibility. Best efforts should
be made to ensure that at least some level flight time is accomplished at ¼-mile or less
visibility to ensure that the spectrum is covered.
(vii) It should be determined that the visibility established at the test sight is
limited by snow and not by fog or poor lighting (twilight) conditions.
(viii) The concentration of snow approaching the inlet in severe recirculation
will far exceed the quantity encountered in the natural snowfall. Recirculation is
necessarily a qualitative judgment by the test pilot. The snow concentration at the inlets
during recirculation would vary for different rotorcraft types and would be dependent on
rotor characteristics, power setting, and inlet location. For test purposes, recirculation
should be the highest snow concentration attainable in the maneuver, or that
corresponding to the lowest visibility at which (in the pilot’s judgment) control of the
rotorcraft is possible in the IGE condition. The ¼-mile or less visibility specification
outside of the recirculation influence becomes inconsequential provided that fresh,
loose snow is continually experienced during the ground operation and IGE hover
testing phase. However, since it is intended that the test phases be accomplished
sequentially to ensure that transition to takeoff and other transients are considered, the
conditions at takeoff, level flight, and descent and landing should approximate the
¼-mile visibility criteria.
Page E - 111
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.