FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page E-102

PDF page 520 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 520
AC 27-1B · E-102Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

AC 27-1B, Chg 4                                                     3/31/2014


interpolation of data from other test conditions can be achieved using the methodology
of the current version of AC 23-8, Flight Test Guide for Certification of part 23 Airplanes.

                  (i) In addition to the preheat requirements of § 27.1093(a)(1), (a)(3), and
(a)(4), the design should consider the possibility of impact ice (supercooled droplets
below freezing) on engine air inlet components opening into the airstream. However,
normal practice is to provide a crew selectable, sheltered, alternate engine air intake
arrangement which, by inspection can be determined to be free from impact ice
accumulations. Typically, a sheltered alternate air source would be acceptable if the
opening is located inside the cowling out of the free airstream. However, precautions
should be taken to assure that backfire flames to be expected do not constitute a fire or
explosion hazard.

                   (ii) For further information review AC 20-113, Pilot Precautions and
Procedures to be Taken in Preventing Aircraft Reciprocating Engine Induction System
and Fuel System Icing Problems, NACA TN 1790, NTSB AAS-72-1, DOT/FAA/CT 84/44
(1982) and NACA TN 1993 (1949).

     b. Turbine Engines - Ice Protection.

         (1) Explanation.

                  (i) This rule requires turbine engines and turbine-engine inlets to perform
satisfactorily in atmospheric icing conditions defined in Appendix C of part 29. On an
equivalent safety basis, the limited icing envelopes described in section 29.1419 of
AC 29-2C may be used to show compliance with the intent of the regulation if the
rotorcraft is limited to not greater than a 10,000-foot pressure altitude for all operations.
If operations are permitted above 10,000 feet, the Appendix C, part 29, envelope must
be used from 10,000 feet to the service ceiling or 22,000 feet. These possible
equivalent safety approaches are not discussed herein. Compliance with the induction
system icing protection rule is required regardless of flight manual limitations or
restrictions against flight into atmospheric icing conditions.

                   (ii) In showing compliance with § 27.1093(b)(1)(i), the FAA/AUTHORITY
has accepted the concept of limited exposure associated with escape from inadvertent
ice encounters.

              (A) It is presumed that there will be a flight manual limitation against flight
into icing conditions, and that the engine induction system will be reevaluated if total
aircraft ice protection certification is requested. Under this concept, the rotorcraft is
assumed to fly directly through the icing environment (i.e., direct sequential penetration
and straight line exit from both the continuous maximum and intermittent maximum icing
clouds). Thus, the duration of exposure to the icing environment could be calculated by
knowing the aircraft flight speed and cloud horizontal extent. A range of engine power
and rotorcraft airspeeds should be evaluated to encompass the operating envelope of
the rotorcraft. Note that aircraft speed has a pronounced effect (Ludlam effect) on ice


Page E - 102

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →