FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page E-82

PDF page 500 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 500
AC 27-1B · E-82Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

AC 27-1B                                                                  9/30/99

         (6) Good design practice suggests that all flammable fluid lines should be
routed to minimize the possibility of rupture in the event of a crash or from engine rotor
disc failure.

AC 27.995.  § 27.995 FUEL VALVES.

     a. Explanation. Valves must be provided in the fuel supply system to each
primary and auxiliary powerplant which will permit positive fuel flow feeding and shutoff
from each fuel supply source. Although the engine throttle control system will provide
one positive fuel shutoff means at the engine fuel control, additional fuel shutoff valves
will normally be required in each fuel supply system to satisfy the requirements of
paragraph (d) of this rule and § 27.1189(c).

     b. Procedures.

         (1) The fuel valve control must be located within easy reach of the appropriate
crewmember and must satisfy the requirements of §§ 27.1141(c) and 27.1189(b).

         (2) If independent fuel supply sources are provided, the fuel valve or valves
must allow independent feeding and shutoff of fuel from each supply source.

         (3) Multiengine rotorcraft fuel systems must have fuel valves which comply with
the requirements of § 27.953(b)(1).

         (4) No fuel valve may be located on the engine side of any firewall. Each valve
should be supported so that loads resulting from its operation or from accelerated flight
conditions are not transmitted to the lines connected to the valve.

         (5) If check valves are included in the fuel supply system, each check valve
should be constructed, or otherwise incorporate provisions, to preclude incorrect
installation of the valve.

AC 27.997.  § 27.997 (Amendment 27-20) FUEL STRAINER OR FILTER.

     a. Explanation. This rule provides for a main in-line fuel filter designed to collect
all fuel impurities which could adversely affect fuel system and engine components
downstream of the filter. The rule also requires a sediment bowl and drain (or that the
bowl be removable for drain purposes) to facilitate separation of contaminates, both
solid and liquid, from the fuel. This section is not intended to require installation of the
filter between the fuel tank outlet and the first fuel system component which is
susceptible to restricted fuel flow because of contaminates (such as a fuel heater or ice
trap equipment).

     b. Procedures.




Page E - 82

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →