Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B 9/30/99
(10) A conservative demonstration would consider the maximum allowable fuel
viscosity in combination with the maximum fuel flow. Otherwise, several test points may
be required.
(11) For those systems which specify a minimum V/L ratio, the methods
provided in Aerospace Recommended Practice (ARP) 492 published by the Society of
Automotive Engineers are acceptable in evaluating test results.
(12) Since the lower quantity of fuel in the tank will reduce the hydrostatic head
and thus the fuel inlet pressure, § 27.955(a)(2) specifies that the quantity of fuel in the
tank should be minimum.
(13) Section 27.955(a)(4) specifies that each main and emergency pump be
evaluated. If it can be determined which pump and flow path is critical, only that
configuration would be tested. Similarly, for suction fuel systems, the critical flow paths
and flow requirements should be evaluated. If pumps are required to supply the
necessary fuel, § 27.1305(c) would require a fuel pressure indicator and § 27.1549
would require a red radial at the minimum safe operating fuel pressure for any fuel or
fuel usage condition. This pressure limit should be used to determine compliance with
§ 27.955(a)(1) for all operations.
(14) Section 27.955(b) requires the fuel system to feed promptly when fuel
becomes low in one tank and another tank is selected. This requirement is important
because momentary fuel flow interruption must be expected to result in complete power
failure and, for single engine rotorcraft, an emergency landing.
AC 27.955A. § 27.955 (Amendment 27-23) FUEL FLOW.
a. Explanation. Amendment 27-23 adds new requirements for test conditions to
ensure that adequate fuel flow is available to the engine in critical combinations of
adverse conditions that may be expected during operation of the rotorcraft. The
amendment also requires a correlation between fuel filter blockage and the fuel filter
warning device required by § 27.1305(q). Design and performance standards for
auxiliary fuel tank and transfer tank fuel systems are provided. These changes were
made to ensure that all parameters associated with fuel supply to the engine are
adequately addressed.
b. Procedures. All of the policy material pertaining to this section remains in effect
with the following additions:
(1) Section 27.955 is intended to ensure adequate fuel flow to the engine(s)
during all operating conditions of the rotorcraft. This includes the fuel flows necessary
to operate the engine(s) under the test conditions required by § 27.927. Testing
(including bench or rig tests) has been the accepted method of showing compliance
with this section although analytical techniques may be used to adjust system test
results to various fuel flow conditions or to account for minor modifications to a system.
Page E - 62
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.