Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Extracted text for finding words
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B, Chg 1 2/12/03
(i) Providing comprehensive criteria to minimize fuel leaks and potential
ignition sources;
(ii) Requiring increased crash load factors for fuel cells in and behind
occupied areas to ensure the static, ultimate strength necessary for impact energy
absorption, structural integrity, fuel containment, and occupant safety;
(iii) Maintaining the load factors of § 27.561 for fuel cells in other areas
(particularly underfloor cells) to ensure leak-tight fuel cell deformation in energy
absorbing underfloor structure without unduly crushing or penetrating the occupiable
volume; and
(iv) Requiring a 50 ft. dynamic vertical impact (drop) test to measure fuel
tank structural and fuel containment integrity.
(2) Section 27.952 applies to all fuel systems (including auxiliary propulsion unit
(APU) systems).
(3) Some similarities exist among the fire protection requirements of §§ 27.863,
27.1337(a)(2), and 27.952. The requirements in each standard are not mutually
exclusive. Overlapping requirements should be certified simultaneously.
(4) The use of bladders is not mandated as this would unduly dictate design.
However, in the majority of cases, their use is necessary to meet the test requirements
of § 27.952. If a design does not use bladders, the application should be treated as a
new and unusual design feature and should be thoroughly coordinated with the
Airworthiness Authority for Technical Policy to insure adequate safety. Experience has
shown that bladders with wall thicknesses from 0.03 to 0.018 inches typically meet the
§ 27.952 test requirements.
b. Related Material. Documents shown below may be obtained from The Naval
Publications and Forms Center, 5801 Tabor Avenue, Philadelphia, Pennsylvania
19120-5094, ATTN: Customer Service (NPODS).
(1) Military Specification, MIL-T-27422B, Amendment 1, April 13, 1971, Tank,
Fuel, Crash-resistant Aircraft. (canceled 6-7-97 without replacement)
(2) Military Standard, MIL-STD-1290 (AV), January 25, 1974, Light Fixed and
Rotary Wing Aircraft Crashworthiness.
(3) Military Standard, MIL-H-83796, August 1, 1974, Hose Assembly, Rubber,
Lightweight, Medium Pressure, General Specification for.
(4) Military Specification, MIL-V-27393 (USAF), July 12, 1960, Valve, Safety,
Fuel Cell Fitting, Crash Resistant, General Specification for.
Page E - 32