FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page E-29

PDF page 447 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 447
AC 27-1B · E-29Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

9/30/99                                             AC 27-1B

                  SUBPART E - POWERPLANT

                         FUEL SYSTEM

AC 27.951.  § 27.951 (through Amendment 27-9) FUEL SYSTEM--GENERAL.

     a. Explanation.

         (1) The term “fuel system” means a system which includes all components
required to deliver fuel to the engine(s). This includes, but is not limited to, all
components provided to contain, convey, drain, filter, shutoff, pump, jettison, meter, and
distribute fuel to the engines.

         (2) Paragraph (a) of this section is a general statement of the performance
requirements for fuel systems and constitutes authority to require the fuel system to be
adequate notwithstanding compliance with detail requirements listed in §§ 27.953
through 27.999 of this subpart.

         (3) Paragraph (b) of this section requires fuel systems to be designed so that
air will not enter the system under any operating conditions by either arranging the
system so that no fuel pump can draw fuel from more than one tank or by other
acceptable means.

         (4) Paragraph (c) of this section sets forth a fuel system performance
requirement intended to ensure that ice to be expected in fuel when operating in cold
weather will not prevent the fuel system from supplying adequate fuel to the engines.
Although fuel system filters and strainers are the items in the fuel system most
susceptible to clogging from ice particles in the fuel, this paragraph requires that the
entire fuel system be shown to be capable of delivering fuel, initially contaminated with
water and cooled to critical icing conditions, to the engine(s).

     b. Procedures.

         (1) For paragraph (a), the applicant should show compliance with the fuel
system requirements of this subpart, except that if unusual fuel system arrangements or
requirements exist which are not adequately addressed by these subparts, this
paragraph may be used as authority to require special tests, analysis, or system
performance needed for proper engine functioning.

         (2) For paragraph (b), review the fuel system design with special attention to
fuel tank selector valves, crossfeed systems, and multiple tank outlet arrangements to
ensure that no fuel system configuration will allow air to enter the system. For
questionable situations, the applicant should conduct ground tests and flight tests as
necessary to verify compliance with this section.




                                                       Page E - 29

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →