Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Extracted text for finding words
This extraction supports search. Read the original page for complete notation and layout.
9/30/99 AC 27-1B
(3) Section 27.923(b) requires the test to be conducted “on the rotorcraft.” This
means a rotorcraft in conformity to the design for which approval is requested.
However, many nonconformity features, such as doors, some cowling and
instrumentation, fuel tanks (alternate external fuel supply may be utilized), interior
features, fire detectors, extinguishers, inlet ducts, exhaust baffles, etc., may be
acceptable provided each item is technically considered and found to be unimportant to
the test results. Any significant deviations from the conformed rotorcraft configuration,
such as using ground or flight test facilities instead of the rotorcraft, providing the
conditions which exist on the rotorcraft can be accurately duplicated, should be defined
in the test proposal and approved by the cognizant FAA/AUTHORITY engineering staff.
The restraint (tie-down) arrangement used during the test will necessarily be arranged
to react rotor thrust loads in lateral as well as vertical directions. However, the restraint
should permit normal deflections due to rotor thrust in the engine and drive system
support arrangement. Safety cables may be installed normal to the tailboom at the tail
rotor gearbox location; however, restraint may be provided to keep airframe deflections
from exceeding those expected in normal and accelerated flight.
(4) The test torque requirements of § 27.923 mean the torque values for which
approval is requested, but must not exceed the values approved for each respective
limit for the engine being used. However, an applicant should be allowed to qualify the
rotor drive system for torque values higher than those for which approval is requested if
the engines actually used are capable of the torque and can be shown by an output
shaft torsional investigation to be equivalent or conservative with respect to torsional
vibration to the engines proposed for the initial certification configuration. Variations in
rotational speed from the certification values should not be allowed except where
careful evaluations of vibration aspects, bearing loads, centrifugal stiffening effects, and
torque variations are conducted.
(5) The rotor configuration required by § 27.923(b) is intended to ensure that
lift, torque, and vibration loads to be expected in service are introduced into the
endurance test, although the presence of the vibration aspects does not normally satisfy
the vibration evaluations required by §§ 27.571 and 27.907. In fact, vibration modes
may be changed and amplified by the tie-down restraints and the increased thrust to be
expected from in-ground-effects on the rotor system. These effects, although
unquantified, are intended as a normal part of endurance testing. Preproduction rotor
blades have been successfully used in endurance tests but only after specific
investigations of blade properties such as stiffness, inertia and inertial distribution, thrust
and blade bending, and torsional frequency response have been carefully compared to
ensure validity of the test. The endurance test includes testing the rotor control
mechanism. Conformity of the rotors may be very significant to this aspect of the test.
(6) For approved designs, some drive system changes or mechanical power
increases may only require partial testing to satisfy § 27.923 requirements provided an
equivalent level of safety finding can be made for the remaining requirements based on
the previously approved data.
Page E - 13