FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page D-132

PDF page 405 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 405
AC 27-1B · D-132Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

AC 27-1B, Chg 7                                                       2/4/2016


            (x) Hoist operator safety device. When hoisting operations require the
presence of a hoist operator on board, appropriate provisions shall be provided to allow
the hoist operator to perform his task safely. These provisions shall include an
appropriate hoist operator restraint system. This safety device is typically composed of
a safety harness and a strap attached to the cabin used to adequately restrain the hoist
operator inside the cabin while operating the hoist. For certification approval, the hoist
operator safety device should comply with § 27.561(b)(3) for personnel safety. The
applicant should submit a design evaluation that assures the necessary level of
personnel safety is provided. The safety harness and strap should meet the
requirements of TSO C22g, TSO C114, or TSO C167; however, as a minimum, the
following should be evaluated:

              (A) The strap attaching point on the body harness should not be located in
the back of the hoist operator due to safety issues in case of a fall or crash.

              (B) The safety device should be designed to be adjustable so that the
strap is tightened behind the hoist operator.

             (C) The strap might include a QRS including a DAD to allow hoist operator
detaching from cabin in emergency conditions (e.g., crash).

             (D) The safety device should be easily and readily ingressed or egressed.

              (E) It should be placarded for proper capacity and lifetime limitation.

              (F) Any fabric used should be durable and should be at least flame
resistant.

       (11) Section 27.865(c)(4) Intercom Systems for HEC Operations. For all HEC
operations, the rotorcraft is required to be equipped for, or otherwise allow direct
intercommunication under any operational conditions among crewmembers and the
HEC. An intercommunications system may also be approved as part of the external
load system, or alternatively a limitation may be placed in the RFM or RFMS as
described under paragraph d.(4)(ii)(B)(2) of this guidance).





Page D - 132

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →