FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page D-99

PDF page 372 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 372
AC 27-1B · D-99Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

2/12/03                                        AC 27-1B, Chg 1


         (2) Advisory Circular 23-2 may be referred to in preparation of test proposals
for flammability tests of interior materials.

         (3) A placard prohibiting smoking may be used if ashtrays are not provided.  If
ashtrays are provided, an adequate number shall be provided, and the installation must
have an inner fire resistant liner to close off the ashtray cavity or receptacle when the
ashtray is removed.

         (4) All illuminated “no smoking” sign or signs must be used when prescribed.
Flightcrew must be able to control illumination of the signs.

         (5) If a hand-held fire extinguisher is installed to comply with an operating rule,
Advisory Circular 20-42C, Hand Fire Extinguishers for Use in Aircraft, contains
acceptable information about hand-held fire extinguishers.

AC 27.853A § 27.853 (Amendment 27-37) COMPARTMENT INTERIORS.

     a. Explanation. Amendment 27-37 requires all materials in the cabin area to be
flame resistant. Section 27.853(b) is now reserved, as the flammability requirements
are not dependent on interior material location or function.

     b. Procedures. The procedures of paragraph AC 27.853 still apply to the
flammability requirements of interior materials except all interior materials must be flame
resistant.

AC 27.855  § 27.855 CARGO AND BAGGAGE COMPARTMENTS.

     a. Explanation.

         (1) Cargo and baggage compartments must be constructed of or lined with-­

                  (i)    Fire resistant material; or

                   (ii)   Flame resistant material for compartments readily accessible to the
crew while in flight.

         (2) A liner or a separately constructed compartment shall protect the aircraft
structure from significant loss of strength in the event of a compartment fire.

         (3) Whenever essential or critical controls, wiring, lines, etc., are located in a
compartment, they must be protected as prescribed.

         (4) For historical reference, this design standard was adopted in 1953 by
Amendment 6-4 to CAR Part 6 for normal category rotorcraft and adopted into
FAR Part 27. The expressed interest, paraphrased from the preamble for the


                                                       Page D - 99

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →