Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
4/25/06 AC 27-1B, Chg 2
(1) The optimum pitch attitude and entry procedure as established in
AC 27.801(b)(1)(i);
(2) The forward speed defined by the knee of the HV diagram reduced by
the wind speed associated with each applicable sea state;
(3) Vertical descent velocity of 5 feet per second; and
(4) Yaw attitudes up to 15°.
(C) The float system attachment hardware should be shown to be
structurally adequate to withstand water loads during water entry when both deflated
and stowed and fully inflated (unless in-flight inflation is prohibited). Water entry
conditions should correspond to those established in paragraphs AC 27.801(b)(1)(ii)(A)
and (B). The appropriate vertical loads and drag loads determined from water entry
conditions (or as limited by flight manual procedures) should be addressed. The effects
of the vertical loads and the drag loads may be considered separately for the analysis.
(D) Probable damage due to water impact to the airframe/hull should be
considered during the water entry evaluations; i.e., failure of windows, doors, skins,
panels, etc.
(E) The ditching maximum demonstrated sea state for water entry is the
same or greater than the maximum demonstrated sea state for flotation and trim.
(2) Flotation Systems.
(i) Normally inflated. Fixed flotation systems intended for emergency
ditching use only and not for amphibian or limited amphibian duty should be evaluated
for:
(A) Structural integrity when subjected to:
(1) Air loads throughout the approved flight envelope with floats installed;
(2) Water loads during water entry; and
(3) Water loads after water entry at speeds likely to be experienced after
water impact.
(B) Rotorcraft handling qualities throughout the approved flight envelope
with floats installed.
Page D - 85
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.