FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page D-82

PDF page 355 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 355
AC 27-1B · D-82Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

AC 27-1B                                                                  9/30/99

         (5) Lamp bulbs should be guarded, recessed, or placed in upper inside corners
and guarded to prevent contact with cargo and possible bulb breakage or excessive
heat.

         (6) If the door design recommendations in paragraph AC 27.787a(6) are
accepted, these features should be confirmed by design data review and during a
compliance inspection. Index or alignment marks with respect to handle (door locked)
position are also recommended.  If a signal system is used, a switch at the door latch
that would signal “door open or unlatched” to the flightcrew is recommended.

AC 27.787A    § 27.787 (Amendment 27-27) CARGO AND BAGGAGE
            COMPARTMENTS.

     a. Explanation. Amendment 27-27 adds two subparagraphs to § 27.787(c) which
clarify that cargo and baggage compartments should be designed to protect occupants
from injury by the compartment contents during emergency landings. This may be done
by location or by retention provisions. The new paragraphs also add a requirement that
the compartment contents not cause injury when subjected to the loads of § 27.561.

     b. Procedures. The procedures of paragraph AC 27.787 are still applicable. In
addition to the forward load, the cargo and baggage compartment should be designed
to withstand loads in other directions as specified in § 27.561. Also, the compartment
may be shown to provide protection of occupants by location; i.e., cargo and baggage
compartments may be shown to be located in a position where loose contents will not
endanger occupants in an emergency landing impact.  If the compartment is located
above or behind the occupied area, § 27.561(c) may apply.  If a compartment is in the
occupied area, § 27.561(b) applies.

AC 27.801  § 27.801 (Amendment 27-11) DITCHING.

     a. Explanation.

         (1) Ditching certification is accomplished only if requested by the applicant.

         (2) Ditching may be defined as an emergency landing on the water, deliberately
executed, with the intent of abandoning the rotorcraft as soon as practical. The
rotorcraft is assumed to be intact prior to water entry with all controls and essential
systems, except engines, functioning properly.

         (3) The regulation requires demonstration of the flotation and trim requirements
under “reasonably probable water conditions.” A sea state 4 is representative of
reasonably probable water conditions to be encountered. Therefore, demonstration of
compliance with the ditching requirements for at least sea state 4 water conditions
satisfies the reasonably probable requirement.




Page D - 82

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →