FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page D-61

PDF page 332 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 332
AC 27-1B · D-61Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

9/30/99                                             AC 27-1B

         (1) The main hull must have multiple compartments. Assuming the hull has
50 percent excess buoyancy capacity, six to ten sealed compartments of approximately
equal volume would allow loss of one with at least 25 percent excess capacity
remaining. However, the attitude of the rotorcraft is critical with respect to capsize
stability, and additional compartments may be necessary.

         (2) The designer must consider separately the loss of buoyancy for each critical
compartment, the aircraft center of gravity, and attitude in the water for the appropriate
sea state or water height. Sea state 4, moderate, as noted in figure AC 27.801-1, is
acceptable.

         (3) The auxiliary floats (outrigger) must have multiple compartments. In
addition, wheel tires may be used as a compartment if applicable to the design.

         (4) For each critical condition under consideration, a single compartment for
either the main hull or auxiliary float should be flooded or collapsed. Combined failures,
one in each, are not required.

         (5) Model stability (or capsize) tests are encouraged to demonstrate
compliance with this section.





                                                       Page D - 61

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →