Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
12/1/2011 AC 27-1B, Chg 4
(3) Critical bonded joints that have high static margins of safety (e.g., some
rotor blades) may be accepted based on satisfactory service history of like or similar
components.
(E) The fatigue load spectrum developed for fatigue testing and analysis purposes
should be representative of the anticipated service usage. Low amplitude load levels
that can be shown not to contribute to fatigue damage may be omitted (truncated).
Reducing maximum load levels (clipping) is generally not accepted.
(F) Environmental effects (temperature and humidity representative of the
expected service usage) on the static and fatigue behavior and damage growth should
be considered. Unless tested in the environment, appropriate environmental knock
down factors for the static and the fatigue test articles should be derived and applied in
the evaluation.
(G) Variability in fatigue behavior should be covered by appropriate load or life
scatter factors and these factors should take into account the number of specimens
tested.
(H) The following Figure AC 27.573-2 illustrates the extent of the impact damage
that needs to be considered in the damage tolerance and fatigue evaluation.
Detectability
Obvious Damage ~
Detectable damage [ ~ ■ Barely Detectable Impac~ /~ . . . . . . . . Damage
+ + +
Undetectable damage + ----+
Zone 1 I I Energy
Level of energy selected for complianec with
§§ 27-305, 27-307 (Static Strength) and fl5)(vi) of this AC.
Maximum level of energy selected for the Damage Tolerance
evaluation. This level should not be exceeded in serviec.
Figure AC 27.573-2. Characterization of Impact Damage.
(1) Both the energy level associated with the static strength demonstration
and the maximum energy level associated with the damage tolerance evaluation
Page C - 107
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.