Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
9/30/2008 AC 27-1B, Chg 3
take into account material and manufacturing variability. The factored curve will then be
used in conjunction with the flight power spectrum to determine a life (limited or
unlimited) for the gears in the primary drive system.
(4) Special procedures, which do not affect fatigue evaluation of the gear teeth,
may be allowed to facilitate completion of the test provided they have been justified and
they do not affect life determination. These include periodic interruption for inspection,
etc., replacement of non-critical parts and the use of special lubricants, special cooling
systems, and methods to prevent unrepresentative deflections at the test torque levels.
(5) From evidence in relation to the strength of steel gears of conventional
design, it is accepted that adequate fatigue strength can be demonstrated by the use of
the above safety factor of 1.4 for a single test, 1.35 for two tests, 1.32 for three tests,
and 1.3 for four or more tests. Where several tests are to be conducted, specimens
should be selected from different manufacturing batches if practicable.
(6) The demonstration of infinite life for gear teeth will normally require tests of
a minimum of 107 cycles duration at factored power levels. Use of shorter duration tests
should be justified.
Page C - 87
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.