Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
9/30/99 AC 27-1B
(iii) When operating on the ground, there may be a tendency for the
aircraft to exhibit a “ground bounce.” For many configurations, this is a benign, although
undesirable phenomenon which may be aggravated by pilot induced oscillations (PIO),
particularly if there is little or no friction on the collective.
(12) Rotorcraft with fully articulated rotor heads and landing gear oleos in either
skid or wheel configuration have tendencies for ground bounce to occur when light on
the oleos, either just prior to takeoff, just after landing contact, or during a power
assurance check. This bounce may induce ground resonance, particularly if the
intensity of the bounce is aggravated by PIO. The corrective action is either to lift off to
a hover or to positively lower the collective and remain on the ground..
(13) Instrumentation and Data Acquisition.
(i) Atmospheric Conditions (to be manually noted):
(A) Altitude.
(B) OAT.
(C) Wind velocity.
(ii) Aircraft Configuration (to be manually noted):
(A) Gross weight.
(B) C.G.
(C) Tire pressure.
(D) Landing gear oleo pressure.
(iii) Instrumentation (for recording during test).
(A) Main rotor RPM.
(B) Time history of cyclic control fore-and-aft and lateral stick position.
(C) Time history of collective control stick position.
(D) Time history of rotor damper motion.*
(E) Time history of pylon component motion.*
(F) Time history of landing gear (oleo) motion.*
(G) Time history of aircraft motions.*
*As required to obtain modal damping
Page B - 67
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.