FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page Apdx B-18

PDF page 1192 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 1192
AC 27-1B · Apdx B-18Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

AC 27-1B, Chg 7                                                                       2/4/2016


responsibility of the operator to demonstrate, and the operations inspector to confirm, that any external
load operation, including en route IFR, can be safely conducted.

        (16) Rotorcraft Flight Below Instrument Flight Minimum Speed.

                  (i) The advent of lateral precision with vertical guidance (LPV) precision GPS approach
procedures may necessitate flying at airspeeds below the previously published instrument flight minimum
speed (VMINI) established for most rotorcraft under Appendix B to part 27, paragraph II(c).

                    (ii) Additionally, some modern automatic flight control systems (AFCS) have been certificated
to fly fully-coupled below previously published VMINI in order to improve operational safety while
conducting certain operations such as Search and Rescue, steep-approaches, and special rig
approaches.

                     (iii) Certification for flight below previously published VMINI will require the applicant to either
reestablish VMINI at a lower airspeed per Appendix B to part 27 or be granted special conditions that
specify the AFCS reliability and functionality requirements that allow for coupled flight below the
previously established VMINI.

                (A) If VMINI is to be reestablished, the certification requirements in Appendix B to part 27
for VMINI must be followed. Among the part 27 requirements, below are two items that are often
overlooked:

                      (1) Static and dynamic stability requirements of Appendix B to part 27 must be
complied with at all approved descent angles.

                      (2) Pilot workload needs to be evaluated at the proposed lower VMINI. Legacy AFCS
may not be able to cope with higher angles of descent, thus increasing pilot workload beyond an
acceptable level.

                (B) The FAA has previously approved special conditions that permit rotorcraft to fly below
airspeeds at which the stability requirements of Appendix B to part 27 cannot be demonstrated. The
bases of these special conditions are that the AFCS has specific modes that permit coupled flight from
VMINI to a minimum airspeed (or groundspeed specified by the applicant), stabilized flight at the minimum
airspeed (or groundspeed), and flight from the minimum airspeed back to VMINI. The following items
should be considered if the applicant chooses to utilize a robust AFCS to permit coupled flight below the
previously established VMINI. These topics are not all-inclusive, but are general considerations. The
actual requirements specified within an individual project’s special conditions will depend on the specific
functionalities provided by the design.

                      (1) The rotorcraft must be certificated for IFR flight and meet the part 29 requirements
for category A engine isolation.

                      (2) For system safety calculations for functional failure modes with operations less
than VMINI, an exposure time of no less than the entire flight duration should be used.

                      (3) The AFCS should provide coupled flight modes that permit safe and controlled
flight in the three axes at all airspeeds (lateral position and speed, longitudinal position and speed, and
height and vertical speed) from the previous VMINI to a hover (within the maximum demonstrated wind
envelope). The AFCS should also provide automatic transition to the helicopter instrument flight
(Appendix B to part 27) envelope as part of normal sequencing. Additional considerations include:

                                     (i) A pilot-selectable “Go-Around” mode to safely interrupt any other coupled
mode and automatically transition to the helicopter instrument flight (part 27, Appendix B) envelope.

                                       (ii) A means to prevent unintended flight below a safe minimum height.


Page Apdx B - 18

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →