Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B, Chg 7 2/4/2016
(12) Cross Coupling. IFR handling qualities are enhanced by providing low levels of coupling
between axes. During the flight evaluation, pilots should be alert for strong cross coupling tendencies
between yaw and pitch, heave (collective) and pitch, heave and roll, or roll and pitch. Any strong coupling
effects between these motions may produce unacceptable handling qualities for IFR flight. The rotorcraft
should be able to make a smooth transition from any flight condition. As an example, large rolling or
pitching moments with collective application would represent questionable handling characteristics for the
IFR missed approach condition.
(13) Electrical, Avionics, and Instruments. Some aircraft have been certificated with different
equipment from that suggested in this subparagraph because the certification criteria for IFR have
evolved in several stages. The following guidance refers to the latest certification requirements:
(i) Additional Avionics and Instruments. The avionics and instruments required for
certification for operations under IFR beyond those required by § 27.1303 should meet the installation
requirements of § 29.1303 as follows:
(A) Attitude Indicator. Power for operation and lighting must be independent from the
rotorcraft electrical generating or starting system, and the instrument markings must meet the minimum
usability requirements of §29.1303(g)(1). Section 29.1303 of this AC provides additional guidance on
marking requirements for attitude indicators. Operation must be maintained for a minimum of 30 minutes
after total aircraft electrical power generating system failure. For dual pilot configurations, one pilot’s
primary indicator may be designated for this purpose, provided standby batteries are provided.
(B) Alternate Static Source. An alternate static source with a means of selecting this
source must be provided for single pilot configurations.
(C) Direction Indication. Gyro Stabilized. Magnetic in place of non-magnetic required by
§ 27.1303(h).
(D) Navigational Systems. Navigational systems required by the applicable operational
rules must be provided.
(E) Communication Systems. Communication systems required by the applicable
operational rules must be provided.
(F) Other electrical and electronic equipment. Other electrical and electronic equipment
required by the applicable operational rules must be provided.
(ii) Electrical Power Availability for Avionic and Instrument Systems. Minimum avionic and
instrument systems should remain operative after electrical power failures in relation to IFR operation.
The lists that follow suggest the minimum Avionic and Instrument Systems that should remain operational
after a single failure of the generating system and after failure of all but the emergency power source.
These lists do not address the basic equipment required for non-IFR related operation. These basic
equipment requirements are addressed by the appropriate paragraph of this guidance.
(A) Avionic and instrument systems that should remain operational, for IFR approved
rotorcraft, after a single failure of the electrical generating system. The rotorcraft must be capable of IFR
flight to destination and alternate airports. The suggested minimum avionic and instrument systems are
as follows:
(1) Flight Instruments - the same as § 27.1303 requirements, except as defined by
paragraphs b.(13)(i)(A) and (C).
(2) Communications - one VHF radio.
Page Apdx B - 14
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.