FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page B-52.1

PDF page 116 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 116
AC 27-1B · B-52.1Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

3/31/2014                                      AC 27-1B, Chg 4


assume the additional load, the remaining engine(s) are not damaged by excessive
power extraction and over-temping. This is needed for compliance with § 27.903(b).
The propulsion engineer should have assured that this feature was properly addressed
in the engine and drive system substantiation; however, it must be assumed that for
some period of time the pilot may extract maximum available power from the remaining
engine(s) when an engine fails during critical flight maneuvers. Substantiation of this
feature should be accomplished primarily by engine and drive system ground tests.

      (5) Longitudinal cyclic authority at VNE with any power setting must permit suitable
nose-down pitching of the rotorcraft.  If the remaining control travel is considered
marginal, tests should include applications up to full control deflection to assess the
remaining authority. Some knowledge of the aircraft’s response to turbulence is useful
in assessing the remaining margin. As a minimum, the rotorcraft must have adequate
margin available to overcome a moderate turbulent gust and must not have any
divergent characteristic which requires full deflection of the primary recovery control to
arrest aircraft motion.  If other controls must be utilized to overcome adverse aircraft
motion, the results are unacceptable (e.g., if a pitch up tendency resulting from an
actual or simulated moderate turbulent gust cannot be satisfactorily overcome by
remaining forward cyclic, the use of throttle or collective controls to assist the recovery
is not an acceptable procedure; however, the use of lateral cyclic to correct roll in
conjunction with forward cyclic to correct pitchup is satisfactory). Obviously during the
conduct of these tests, all available techniques should be utilized when the pilot finds
himself “out of control.” However, compliance with this section requires that recovery
must be shown by use of only the primary control for each axis of aircraft motion.

         (6) Cyclic control authority in autorotation must be sufficient to allow adequate
flare capability and landing under the all engine inoperative requirements of § 27.75
(see section 27.75 of this AC).





                                                        Page B - 52.1

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →