FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

PDF page 1039

PDF page 1039 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 1039
AC 27-1B · 1039Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

AC 27-1B, Chg 7                                                                       2/4/2016


                (C) The intended user (pilot) of the system does not require any exceptional skill,
strength, or alertness to operate the system.

                (D) Proper integration and compatibility with other controls or displays, or both, and with
other equipment in the cockpit.

                (iv) Typically, rotorcraft systems are designed to minimize failures. However, if a system
failure occurs, the pilot should be able to continue safe operation of the rotorcraft. Pay particular attention
to the hazards of presenting misleading information to the pilot in the event of malfunction. Applicants are
encouraged to conduct early analyses and evaluations of new systems to facilitate timely identification
and resolution of HF related certification issues.

         (2) The following is a partial listing of the HF-related regulations and associated discussion of
each of those regulations with considerations for demonstration of compliance.

                  (i) Section 27.672.

                (A) Section 27.672(a). Provide a warning signal that is distinguishable from other cockpit
alerts.  If an audio signal is used, the pilot must be able to discriminate it from all other cockpit audio
alerts.

                      (1) Conduct evaluations in the rotorcraft during both ground and flight operations with
varying levels of background noise.

                      (2) Assess the discriminability of the visual and auditory alert in multiple alert
scenarios, if applicable.

                      (3) Applications that employ voice technology should meet these same criteria.

                      (4) Conduct analysis, simulation, or flight test to show that the system would not
produce nuisance alerts when the rotorcraft is conducting normal flight operations.

                (B) Section 27.672(b). Determination of exceptional pilot skill or strength is subjective.
When evaluating for "exceptional pilot skill," evaluators should consider the complexity of the task in
terms of the performance requirement (level of accuracy or precision), the number of steps, memory load,
checklist use, time-to-perform, and, if needed, training requirements. The test pilots involved in the
program normally do these evaluations. For "exceptional pilot strength," it is also important to conduct
evaluations considering the minimum strength capabilities of the pilot. Consider using pilots that
represent a fifth percentile female as the low-end of the strength spectrum.

                      (1) There is guidance that may be useful to applicants in determining strength
considerations in section 27.143 of this AC and the strength study in Human Force Exertions in Aircraft
Control Locations, report no. AMRL-TR-71-119, February 1972. This study provides several examples of
maximum force exertion from various locations of controls in the cockpit; however, there are always
unique situations that can arise during the design of a new or modified cockpit.

                      (2) When new or unique situations arise, conduct evaluations early on to ensure that
the strength required to activate the control does not fall outside the limitations of the pilot population.

                    (ii) Section 27.679. A number of accidents have occurred because pilots have tried to take
off with either the manufacturer’s control lock or a substitute device in place. A couple of issues can
cause this problem. One is whether the "unmistakable warning to the pilot” is, in fact, unmistakable.
Another is the use of unapproved devices to lock the control system. Various approaches and devices
have been developed to make it apparent that the control is locked. When evaluating a control lock
system, consider several factors in finding compliance with the regulation.



Page MG 20 -10

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →