Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Extracted text for finding words
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B, Chg 7 2/4/2016
(3) Attention-getting cues: When selecting the type of attention-getting cue, a text
change by itself is typically inadequate to annunciate automatic or uncommanded mode changes.
(i) Use audio tones or voice messages. Keep the number of different tones to a
minimum to decrease the possibility of confusion. Aircrew alerts are more noticeable when a combination
of audio tone/audio message and a visual cue is used.
(ii) Blinking or Flashing. Blinking information elements such as readouts or
pointers can be effective methods of annunciation. However, the use of blinking or flashing should be
limited because it can be distracting, and excessive use reduces the attention-getting effectiveness. Use
blinking rates between 0.8 and 4 hertz, depending on the display technology and the compromise
between urgency and distraction. If blinking of an information element can occur for more than
approximately 10 seconds, there should be a means provided to cancel the blinking.
(5) Flight and Navigation Display of Information on the PFD.
(i) Flight. At a minimum, the primary flight display portion of the PFD should display the
attitude, airspeed, altitude, and heading. Most EDS flight displays also include navigation guidance in the
form of course deviation, and if applicable, vertical glide path deviation. They can also include
information on vertical speed indications, radar altitude, and flight guidance mode. If synthetic vision (SV)
is incorporated, it should be on the flight display as a “pilot-view out the window” (egocentric) format. If
incorporating SV into the flight display, it should provide the same level of accuracy and validity as the
other navigation sources. If displayed on the PFD, describing the SV’s intended function as “situational
awareness only” or “not required” to justify a lower design assurance level is not acceptable.
(A) Information.
(1) PFI refers to those functions or parameters that are required by the airworthiness
and operational regulations such as airspeed, altitude, attitude, and heading (direction). 14 CFR part 27
only requires airspeed, altitude, and heading (direction) as PFI unless the rotorcraft will be certificated for
IFR. IFR certifications require instrumentation defined in 14 CFR 27 Appendix B. Most EDS designs
include attitude, altitude, airspeed, and heading display in the basic “T” arrangement defined in
§ 29.1321. There are specific requirements contained in TSOs for the display of each of these
parameters.
Note: TSO approval does not authorize installation of a system or instrument into a rotorcraft. The
installation of an instrument or system must meet the certification requirements for the rotorcraft.
For example, some attitude indicators carry TSO-C4 approvals but are not qualified for
installation in rotorcraft where an ADI is required by the certification rules.
(2) Part 27 rotorcraft certificated to operate under VFR only may require secondary
sources of PFI depending:
(i) On the operational rules for the rotorcraft (i.e., part 91 versus part 135).
(ii) Whether the failure hazard assessment and system safety assessment
(FHA/SSA) show that the failure condition classification warrants redundancy.
(3) PFI for IFR Rotorcraft.
(i) For IFR rotorcraft, the PFI requirements are contained in Appendix B to Part
27, VIII (refer to Appendix B of this guidance for more information). If using an integrated electronic
display as a secondary source or standby instrument, there should be arrangement of the PFI in the basic
T-configuration on the display. Additionally, PFI is considered essential for safe operation and should
meet minimum standards of applicable TSOs or equivalent and must meet the requirements of § 27.1309
Page MG 19 -18