Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
2/4/2016 AC 27-1B, Chg 7
(i) Computer generated displays provide the ability to present a multitude of information. As a
result, numerous formats are possible with an electronic display system. However, excessive information
on a limited display size can result in clutter, resulting in reduced efficiency of pilot cues, pilot scan, and
detection.
(A) The density of information on the display should be compatible with the pilot's ability
to recognize essential information and to minimize misinterpretation. At times, pilots may wish to reduce
clutter by removing the display of symbols otherwise used during specific phases of flight.
(B) There should be an information prioritization scheme established to ensure the clear
presentation of essential information.
(C) If anticipating clutter, there should be a means provided for manual de-cluttering.
Automatic de-cluttering, such as during specific phases of flight, or during certain alerts, may also be
appropriate.
(ii) Clutter should be a major consideration during the reversionary or compacted display
modes. When combining essential information on a display after another display or unit fails, the display
format should not be confusing and the information should still be usable, including ability to display
unusual attitudes.
(iii) Unusual attitude and de-cluttering of the PFD.
(A) All primary attitude displays should provide an immediately discernable attitude
recognition capability that fosters a safe and effective unusual attitude recovery capability. The display
should provide sufficient cues to enable the pilot to maintain full-time attitude awareness and minimize
potential for spatial disorientation.
(1) The display should support the initiation of recovery from unusual attitudes within
1 second with a minimum correct response rate of 95 percent.
(2) Additional information included on primary flight reference displays should not
interfere with maintaining attitude awareness, recovering from an unusual attitude, or the interpretation of
any primary flight information. Consider removing information not used in unusual attitude recovery.
(B) Annunciations and Indications.
(1) General. Annunciations and indications include annunciator switches, messages,
prompts, flags, and status or mode indications, which are on the flight deck display itself or control a flight
deck display. Refer to § 27.1322 for specific annunciations and indications such as warning, caution and
advisory level alerts.
(i) Annunciations and indications should be operationally relevant and limited to
minimize the adverse effects on flightcrew workload.
(ii) Annunciations and indications should be clear, unambiguous, and consistent
with the flight deck design philosophy. When providing annunciation for the status or mode of a system,
the annunciation should indicate the actual state of the system and not just the position or selection of a
switch. Annunciations should only be indicated while the condition exists.
(2) Location. Annunciations and indications should also be consistently located in a
specific area of the electronic display. Annunciations that may require immediate flightcrew awareness
should be located in the flightcrew’s forward, primary field of view. There may be CAS messaging
presentation in the pilot’s secondary field of view if there is a Master Caution/Warning indicator.
Page MG 19 - 17
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.