Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
9/30/99 AC 27-1B
CHAPTER 3
AIRWORTHINESS STANDARDS
NORMAL CATEGORY ROTORCRAFT
MISCELLANEOUS GUIDANCE (MG)
AC 27 MG 10 ADVISORY MATERIAL FOR SUBSTANTIATION OF EMERGENCY
FLOTATION SYSTEM
a. Reference. FAR sections 27.521, .563(b), .751, .753(a)(1), (a)(2), .801(b),(d),
.807(d).
b. Explanation.
(1) This section pertains to emergency flotation systems used to provide
buoyancy for rotorcraft not specifically certificated for ditching but performing over-water
operations. According to paragraph AC 27.801, ditching may be defined as an
emergency landing on the water deliberately executed with the intent of abandoning the
rotorcraft as soon as practical. Currently, ditching certification is not required by
FAR 27; however, certification requirements are prescribed for applicants requesting
ditching certification approval. If a rotorcraft operates over water during a Part 135
operation, the rotorcraft must comply with FAR 135.183, which may require floats.
(2) There are no airworthiness rules specifying the minimum standards for
emergency flotation systems on rotorcraft not certificated for ditching requirements.
Equipment presented for evaluation must perform its intended function and not create a
hazard for the rotorcraft or occupants. The objective in evaluating emergency flotation
systems is safe flight and evacuation of the rotorcraft in emergency situations.
Adequate emergency flotation systems would aid in keeping rotorcraft sufficiently
upright and in adequate trim to permit safe and orderly evacuation in an emergency
water landing.
c. Procedures. The following guidance criteria is based on past certification policy
and experience for emergency flotation systems. Demonstration of compliance to other
criteria may produce acceptable results if adequately justified by rational analysis.
Model tests of the appropriate emergency water landing configuration may be
conducted to demonstrate satisfactory flotation and trim characteristics where
satisfactory correlation between model testing and flight testing has been established.
Model tests and other data from rotorcraft of similar configurations may be used to
satisfy the water requirements where appropriate.
(1) Flotation Systems.
(i) Normally inflated. The flotation systems which are normally inflated
and intended for emergency use only, should be evaluated for:
Page MG 10 - 1
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.