Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
3/31/2014 AC 27-1B, Chg 4
AC 27.1547. § 27.1547 (Amendment 27-13) MAGNETIC DIRECTION
INDICATOR.
a. Explanation. This section identifies the requirement and location for a
calibration placard for the magnetic direction indicator.
b. Procedures. One means of accomplishing the requirements of this regulation
is commonly known as swinging the compass. A surveyed compass rose is laid out on
an appropriate surface. The compass rose location should be free from the influence of
steel structures, underground pipes and cables, reinforced concrete, and other aircraft.
The aircraft should be in an attitude that permits an accurate result. Normally the
engines are in operation; however, if the aircraft is equipped with an auxiliary power unit
which can supply electrical power for all electrical/electronic equipment or systems, this
can be used instead of engine driven generators. Turn the aircraft on successive
headings through 360°. It is recommended that the increments be every 30°; however,
the increments should not exceed 45°. Prepare a placard to show the correction to be
applied at each of the selected headings. When deviations of more than 10° are
introduced by operation of any electrical/electronic equipment or systems, the placard
should also be marked at each calibration heading showing the correction to be applied
when such equipment or systems are turned on or energized. The placard resulting
from this calibration should be installed on or near the magnetic direction indicator and
identify which electrical loads, or combination of loads, are the cause of the excessive
deviations.
Page G - 25.9
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.