FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page E-90

PDF page 508 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 508
AC 27-1B · E-90Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

AC 27-1B                                                                  9/30/99

before the filter reaches a bypass condition. The indicator may be a pop-out button or
other maintenance cue that is checked on each preflight inspection.

AC 27.1021.    § 27.1021 OIL SYSTEM DRAINS.

     a. Explanation. This regulation requires provisions be provided for safe drainage
of the entire oil system with the rotorcraft at normal ground attitude and defines certain
requirements for assuring that no inadvertent oil flow occurs from the system provided.

     b. Procedures.

         (1) The design of the oil system must provide a means for safe drainage of the
entire oil system. This may require one or more drains depending on the design of the
system. The routing of fluid lines should be such that drooping lines and fluid traps
which are undrainable are avoided.

         (2) The drain(s) must provide a means for a positive lock in the closed position.
The method by which the lock is accomplished may be manual or automatic.

AC 27.1027.    § 27.1027 (Amendment 27-23) TRANSMISSION AND GEARBOXES:
            GENERAL.

     a. Explanation. Amendment 27–23 adds a new § 27.1027. This new section
provides the regulations for rotorcraft transmission and gearbox lubrication systems.  It
incorporates lubrication system requirements that were derived from existing engine oil
system requirements. These additional requirements have been adjusted or modified to
reflect the needs of transmissions and gearboxes. Transmission and gearbox
lubrication system regulations are similar to those for engines; therefore, reference is
made to the engine lubrication sections as applicable.

     b. Procedures.

         (1) The pressure lubrication systems for rotorcraft transmissions and gearboxes
should comply with the same requirements as the engine lubrication systems stipulated
in §§ 27.1013 (except §§ 27.1013(c)), 27.1015, 27.1017, 27.1021, and 27.1337(d).
These sections provide the requirements for oil tanks, tank tests, oil lines and fittings,
and oil system drains.

         (2) Each pressure lubrication system for rotorcraft transmissions and
gearboxes should have an oil strainer or filter. The strainer or filter should:

                  (i)   Remove any contaminants from the lubricant which may damage the
transmission, gearbox, or other drive system component and any contaminants that
may impede the lubricant flow to a hazardous degree.




Page E - 90

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →