Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B 9/30/99
device during transition thereby increasing its serviceability and reliability. Note that
damper design and locations become more complex as selected operating speed
increases through the third or fourth critical frequency. Multiple node points will exist
where dampers will not be effective. Production specimen testing at high speed/high
torque conditions should include checks for shaft straightness until experience verifies
that shaft deflecting is not significant. For systems utilizing squeeze film dampers at the
support bearings, variations in oil pressure, flow restrictions, and the effects of bearing
preload should be evaluated. The effects of shaft and unbalance and the proximity of
the damper to bottoming under maximum unbalance should be evaluated.
(3) If the shafting configuration of the rotorcraft includes universal joints or
misalignment couplings, a velocity differential will exist across the joint which creates
sinusoidal torques and bending moments at both shafts at multiples of the rotation
speed. To avoid amplification of these torques and bending moments, the design
should preclude coincidence of critical speeds and multiples of normal speeds.
(4) Order 8110.9, Handbook on Vibration Substantiation and Fatigue
Evaluation of Helicopters and Other Power Transmission Systems, also addresses this
subject. This document is distributed to section level and above in all Regional Aircraft
Certification Offices.
Page E - 24
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.