Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B, Chg 4 3/31/2014
Eligible ambient atmospheric conditions, prestart requirements (to allow for waste fuel
drainage), starter duty cycle (if different from the ground start duty cycle), and prestart
situation analysis should be included. The prestart situation analysis should consider
the following questions:
(i) Should a restart be attempted in view of the cause for initial shutdown?
(ii) Is inlet system ice ingestion a possibility?
(iii) Is re-ignition of fuel in the engine nacelle a possibility?
(iv) Is sufficient restart time available?
(v) Is power available?
(vi) Is altitude sufficient to maintain terrain clearance?
The restart capability can consider wind milling of the engine as part of this restart
capability; however, most rotorcraft airspeeds and the locations of the engines do not
support engine wind milling up to start speeds. Only electrical power requirements were
considered for restarting; however, other factors that may affect this capability are
permitted to be considered. Engine restart capability following an in-flight shutdown of
all engines is the primary requirement, and the means of providing this capability is left to
the applicant.
To minimize any potential height loss, engine restart should be available at the earliest
opportunity. The engine certification should be checked to ensure that the flight manual
instructions for in-flight restart are consistent with any specific engine restart
requirements.
Page E – 10
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.