Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
06/28/18 AC 27-1B, Chg 8
off the rotor do not result in distractions to the pilot. The effect of cabin lighting on the
pilot compartment view should be assessed, particularly on EMS-configured aircraft
where the in-flight use of cabin lights may be mandatory.
(3) Moderate rainfall is defined by the National Weather Service as an
accumulation of between 0.01 and 0.03 inches in 3 minutes. Since the rule effectively
permits open cockpits, a determination of what would unduly impair the pilots’ view in
moderate rainfall is obviously very subjective. If it is established that rain removal
systems are necessary, those systems may be evaluated on the ground with a hose,
but they should also be assessed in flight under applicable conditions. Obscuration of
side windows by rainfall should be addressed, particularly for confined area
approaches. The need for windshield wash systems should be assessed if the aircraft
will be used in an offshore salt-spray environment.
(4) If icing certification is requested, a means must be provided to ensure that a
sufficiently large viewing area is kept clear of ice to permit safe operation. As a
minimum, a clear area on the windshield should be available, although some
configurations could require a clear view in other areas to provide an adequate level of
safety in certain operations. Systems provided to ensure a clear view in icing conditions
should be evaluated during icing flight tests.
D - 66
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.