Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Extracted text for finding words
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B, Chg 2 4/25/06
AC 27.602 § 27.602 CRITICAL PARTS.
a. Explanation.
(1) Critical parts requirements apply to structural components, rotor drive
systems, rotors, and mechanical control systems.
(2) The objective of identifying critical parts is to ensure that critical parts are
controlled during design, manufacture, and throughout their service life so that the risk
of failure in service is minimized by ensuring that the critical parts maintain the critical
characteristics on which certification is based.
(3) Definitions with respect to § 27.602:
(i) The use of the word “could” in paragraph 27.602(a) of the rule means
that this failure assessment should consider the effect of flight regime (i.e., forward
flight, hover, etc.). The operational environment need not be considered.
(ii) With respect to this rule, the term “catastrophic” means the inability to
conduct an autorotation to a safe landing, without exceptional piloting skills, assuming a
suitable landing surface is available.
(iii) The use of the word “and” in paragraph 27.602(a) of the rule means
the part must have both a catastrophic failure mode together with one or more critical
characteristics.
(iv) With respect to this rule, the term “part” means one piece, or two or
more pieces permanently joined together.
(v) With respect to this rule, the term “critical characteristic” means any
dimension, tolerance, finish, material, or any manufacturing or inspection process, or
other feature which cannot tolerate variation from type design requirements and, if
nonconforming, would cause failure of the critical part.
(4) Many rotorcraft manufacturers already have procedures in place within their
companies for handling “critical parts.” These plans may be required by their dealings
with other customers, frequently military (e.g., US DoD, UK MoD, Italian MoD).
Although these plans may have slightly different definitions of “critical parts” which have
sometimes been called “Flight Safety Parts,” “Critical Parts,” “Vital Parts,” or “Identifiable
Parts,” they have in the past been accepted as meeting the intent of this requirement
and providing the expected level of safety. It is acceptable for these plans to use
alternative names and terminology provided they meet the intent of this requirement.
b. Procedures. The rotorcraft manufacturer should establish a Critical Parts Plan,
which identifies and controls the critical characteristics. The policies and procedures
which constitute that plan should be such as to ensure that-
Page D - 2