FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page C-40

PDF page 190 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 190
AC 27-1B · C-40Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

AC 27-1B, Chg 4                                                     3/31/2014


             SUBPART C - STRENGTH REQUIREMENTS

               EMERGENCY LANDING CONDITIONS


AC 27.561 EMERGENCY LANDING CONDITIONS--GENERAL.

   a. Explanation.

      (1) Occupant protection. The occupants should be protected as prescribed from
serious injury during an emergency, minor crash landing on water or land for the
conditions prescribed in the standard. The standard states that each occupant should
be given every reasonable chance of escaping serious injury in a minor crash landing.
In addition, the occupants shall be protected from items of mass inside the cabin as well
as outside the cabin. For example, a cabin fire extinguisher must be restrained for the
load factors prescribed in this section (reference § 27.1411(b)(2).) A transmission or
engine must be restrained to the load factors in § 27.561(b)(3) if located above or
behind the occupants.

      (2) Load factor determination. The standard in § 27.561(b)(3) specifies certain
ultimate inertia load factors but allows a lesser downward vertical load factor by virtue of
a 5 FPS ultimate rate of descent.

      (3) Retractable landing gear. For rotorcraft equipped with retractable landing gear
only the retracted configuration must be considered.

      (4) Door and exit protection. The minor crash conditions contained in
§ 27.561(b)(3) should also be considered in designing doors and exits (§ 27.807(b)(4)).

      (5) External load considerations. The load factors of § 27.561 and the criteria of
§ 27.562 are not directly applicable to external load systems. This is because in
emergency crash scenarios that involve external loads, the external load is neither
typically subjected to the same minor crash loads (§ 27.561) as is the rotorcraft hull and
its internal occupants nor are all of the occupant protection criteria (§ 27.562) needed or
practicable to apply. Appropriate safety for external load carriage systems is provided
by the criteria of § 27.865. Safety standards for external load attaching means are
provided in § 27.865.

     b. Procedures.

      (1) The design criteria report or another similar report of the rotorcraft structural
limits should contain the (ultimate) minor crash condition load factors.

      (2) Section 27.785 (section 27.785 of this AC) concerns application of this design
standard to seats, berths, belts, and harnesses.



Page C - 40

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →