FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page C-37

PDF page 187 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 187
AC 27-1B · C-37Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

9/30/99                                             AC 27-1B

             SUBPART C - STRENGTH REQUIREMENTS

                      WATER LOADS


AC 27.521  § 27.521 FLOAT LANDING CONDITIONS.

     a. Explanation. This is an optional requirement for float operations. The
regulation specifies vertical loads, aft loads, and side loads to be applied to the float
installations. The two loading conditions to be applied are:

         (1) Up-load Condition.

                  (i)   A vertical load appropriate to a landing load factor determined under
§ 27.473(b).

                   (ii)  A resultant water reaction passes vertically through the aircraft CG.

                    (iii)  An aft load equal to 25 percent of the vertical load.

         (2) Side-load Condition.

                  (i)   A vertical load equal to 75 percent of the vertical load for the up-load
condition, equally divided among the floats.

                   (ii)  A side load at each float equal to 25 percent of the vertical load
specified for the side load condition.

     b. Procedures.

         (1) The vertical load factor is determined by drop tests in accordance with
§§ 27.473(b) and 27.725. The floats may be drop tested, or they may be assumed to
have the same load factor as wheeled gear which have been drop tested.

         (2) Structural substantiation may be accomplished by either static tests or
analysis using the specified loads. The load distribution on the floats may be realistic,
based on hydrostatic pressure distributions, or conservative.





                                                          Page C - 37

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →