Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B 9/30/99
AC 27.305. § 27.305 STRENGTH AND DEFORMATION.
a. Explanation.
(1) This general rule defines, in relative terms, allowable deformation for limit
and ultimate loads.
(2) The structure is required to be able to support, in a static test, ultimate loads
for 3 seconds without failure, or dynamic tests simulating actual load application may be
used.
(3) Section 27.307 concerns proof of the structure and requires certain
specified tests. This rule also allows substantiation by structural analysis. See
paragraph AC 27.307.
b. Procedures. Any test results, static or dynamic, should satisfy the limitations or
acceptance criteria contained in the rule.
(1) Any test proposals submitted for approval that are used to demonstrate
compliance with sections of Part 27 should contain the criteria stated in the rule.
(2) Any test results reports shall contain data and information showing the test
results comply with the standard.
AC 27.307. § 27.307 (Amendment 27-3) PROOF OF STRUCTURE.
a. Explanation.
(1) The rule requires compliance with the strength and deformation
requirements for each critical loading condition. Certain tests must be conducted as
specified. Additional tests for new or unusual design features may be required as noted
in § 27.307(b)(6).
(2) Structural analysis rather than load tests may be used only if the structure
conforms to those for which experience has shown the structural analysis method to be
reliable.
b. Procedures.
(1) The design criteria and/or design loads report should contain typical or
representative loading conditions from which the critical loading conditions will be
selected for analytical substantiation in structural (static and fatigue) reports, dynamics
(vibration and stability) reports, and in fatigue, static, dynamic, or operational test
reports.
Page C - 2
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.