Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Extracted text for finding words
This extraction supports search. Read the original page for complete notation and layout.
AC 27-1B, Chg 1 2/12/03
(MANUAL IDENTIFICATION)
ATTACHMENT 4
TYPE DESIGN CHANGE
ICA RECOMMENDED PROCEDURES
(Continued)
Requirement Regulation Location
(N/A) Scheduling information for the (N/A) rotorcraft’s auxiliary A27.3(b)(1) N/A
power unit(s)(APU) that provides the recommended periods at
which they should be (N/A) cleaned, (N/A) inspected,
(N/A) adjusted, (N/A) tested, (N/A) lubricated and (N/A) the work
recommended at these periods.
(N/A) Scheduling information for the (N/A) rotorcraft’s rotor(s) that A27.3(b)(1) N/A
provides the recommended periods at which they should be (N/A)
cleaned, (N/A) inspected, (N/A) adjusted, (N/A) tested,
(N/A) lubricated and (N/A) the work recommended at these periods.
( Y ) Scheduling information for the ( Y ) rotorcraft’s accessories A27.3(b)(1) See
that provides the recommended periods at which they should be ( Y ) NOTE 3
cleaned, ( Y ) inspected, ( Y ) adjusted, ( Y ) tested, ( Y )
lubricated and ( Y ) the work recommended at these periods.
( Y ) Scheduling information for the ( Y ) rotorcraft’s instruments A27.3(b)(1) See
that provides the recommended periods at which they should be ( Y ) NOTE 3
cleaned, ( Y ) inspected, ( Y ) adjusted, ( Y ) tested, ( Y )
lubricated and ( Y ) the work recommended at these periods.
( Y ) Scheduling information for the ( Y ) rotorcraft’s equipment A27.3(b)(1) See
that provides the recommended periods at which they should be ( Y NOTE 3
) cleaned, ( Y ) inspected, ( Y ) adjusted, ( Y ) tested, ( Y )
lubricated and ( Y ) the work recommended at these periods.
( Y ) The degree of inspection for each part of the (N/A) rotorcraft A27.3(b)(1) ATA 5
and its (N/A) engine(s), (N/A) auxiliary power unit, (N/A)
rotor(s), ( Y ) accessories, ( Y ) Instruments and
( Y ) equipment.
( Y ) The applicable wear tolerances A27.3(b)(1) ATA 25
The applicant may refer to an (N/A)accessory, (N/A) instrument, or A27.3(b)(1) N/A
(N/A) equipment manufacturer as the source of this information if
the applicant shows (N/A) that the item has an exceptionally high
degree of complexity requiring specialized maintenance techniques,
test equipment, or expertise.
( Y ) The recommended overhaul periods and necessary cross A27.3(b)(1) ATA 5
references to the Airworthiness Limitation Section.
Figure 2 (continued)
REVISION: (DATE)
Revision 4 Page 7
Page Apdx A - 68