FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page Apdx A-15

PDF page 1118 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 1118
AC 27-1B · Apdx A-15Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

2/12/03                                          AC 27-1B, Chg 1

                                      (MANUAL IDENTIFICATION)
                        CHAPTER 1
                       INTRODUCTION
                                    (Continued)

   d. The manual should not be in a mixed arrangement, i.e., a mixture of written text on both
sides of a page and written text on one side of a page. The preferred method is written text on
both sides of a page.

   e. When there is no written text for a page, the page should contain the following statement:
                 THIS PAGE INTENTIONALLY LEFT BLANK
The page should be identified in the same manner as the rest of the pages in the manual and the
page listed in the List of Effective Pages.

7. SUPERSEDED DOCUMENTS. For Type Design Changes, the ICA should contain the
following statement:
  Superseded Documents: The information, procedures, requirements, and limitations
  contained in this Instructions for Continued Airworthiness for this type design change
  supersede the information, procedures, requirements and limitations contained in the
   rotorcraft’s maintenance manual when the type design change is installed on the
  Type Certificate Holder’s rotorcraft.

8. APPLICABILITY. The ICA should include the make, model, and serial number (if
applicable) of rotorcraft to which the ICA apply.

9. DEFINITIONS. Some words or terms used in the ICA require defining in the Introduction.
AUTHORITY means another airworthiness authority that has adopted this ICA.

10. ABBREVIATIONS. Abbreviations used in the ICA should be listed with their words/terms
in the Introduction of the ICA.
   a. FAA/AUTHORITY = Federal Aviation Administration or another airworthiness authority
   b. FAR = Federal Aviation Regulation
   c.  ICA = Instructions for Continued Airworthiness
   d. JAR = Joint Airworthiness Regulations
   e. LOAP = List of Applicable Publications
     f. TDC = Type Design Changes

11. ACRONYMS. Acronyms used in the ICA should be listed with their terms in the
Introduction of the ICA.




  REVISION:                                       (PAGE NUMBER)
   Revision 4                                                      01-00-00  Page 3


                                                                  Page Apdx A - 15

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →