Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
2/12/03 AC 27-1B, Chg 1
AC 27.805 § 27.805 (Amendment 27-37) FLIGHT CREW EMERGENCY EXITS.
a. Explanation.
(1) Amendment 27-37 increases the maximum gross weight of a normal
category rotorcraft from 6000 pounds to 7000 pounds and adds a passenger seat
limitation of nine. In conjunction with the weight and passenger limitation and to support
a potential increase of passengers, § 27.805 was added that required flight crew
emergency exits when passenger exits are not convenient. The placement of litters,
cargo, or bulkheads may prevent passenger exits from being convenient to the flight
crew. Flight crew exits, if required, are to be of sufficient size and located on both sides
of the rotorcraft (or one top hatch) to allow “rapid evacuation of the flight crew.” This
must be shown by test(s) to demonstrate compliance.
(2) If equipped with emergency flotation devices, the rule requires that the
water or flotation devices do not obstruct the flight crew emergency exits after an
emergency landing on water. This must be shown by test, demonstration, or analysis.
b. Procedures.
(1) Flight crew emergency exits, if required, may consist of one overhead hatch
or two side exits (one on either side). The size is not explicitly defined except that it be
“of sufficient size . . . to allow rapid evacuation of the flight crew”. The ability for “rapid
evacuation” is to be demonstrated by tests. For side exits located immediately adjacent
to the crew seat and exceeding an unobstructed opening that provides a 19- by 26-inch
ellipse (§ 27.807) in size, the test demonstration can be accomplished by normal use
and evaluation of the exits by the certification authority during Type Inspection
Authorization (TIA) testing. For any overhead exit or side of fuselage exits not meeting
the 19- by 26-inch ellipse dimensions, a special demonstration test should be
accomplished. This demonstration should show that 2.5 percentile to 97.5 percentile
men could egress rapidly through the crew exit(s), i.e., men 5 feet 4 inches to
6 feet 5 inches in height and up to 225 pounds in weight, based on the Civil
Aeromedical Institute’s (CAMI) 1998 Aeromedical Certification Statistical Handbook. If
an overhead hatch type exit is utilized, on conventional rotorcraft designs, hazards
associated with the proximity of rotor blades should be considered.
(2) The tests, demonstrations, or analysis required by § 27.805(c) for flight crew
exits are analogous to those of § 27.807(a)(3) except the crew exit threshold may be
slightly below the water line but should not obstruct use of the exit. Tests in water
(tanks or large bodies of water) or demonstrations in the laboratory may be used for
compliance if the deflections of flotation devices relative to the exits are accurately or
conservatively achieved.
AC 27.807. § 27.807 (Amendment 27-21) EMERGENCY EXITS.
a. Explanation. The specified emergency exits are as follows:
Page D - 91
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.