Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Extracted text for finding words
This extraction supports search. Read the original page for complete notation and layout.
AC 27.1B, Chg 4 5/1/2014
• Paragraphs that do not correspond with a FAR number either remain in Chapter 3 and are
renumbered as MG paragraphs, or are now an appendix.
• In order to stay aligned with FAR numbering, Appendices A and C are reserved for future AC
material.
b. Paragraphs revised to incorporate technical guidance are AC 21.35, 27.561, 27.952, 27.1305,
27.1309, 27.1351, 27.1353, MG 2, and MG 4 (FADEC). AC 27.661, Rotorblade Clearance, contains
new material added as a result of National Transportation Safety Board (NTSB) recommendations.
c. New paragraphs added are AC 27.1B and 27.2A, Gross Weight; AC 27.602, Critical Parts; and
AC MG 12, External Loads. These paragraphs correspond with recent harmonized regulatory
changes.
d. The AC is now divided by Subparts and page numbers reflect the relevant FAR Subpart.
e. “FAA/AUTHORITY” as used in this document means FAA or another airworthiness authority
that has adopted this AC as a means of compliance with the appropriate regulation referenced.
5. DEVIATIONS. As rotorcraft designs vary from conventional configurations, it may become
necessary to deviate from the methods and procedures outlined in this AC. These procedures are
only one acceptable means of compliance with Part 27. Any alternate means proposed by an
applicant will be given due consideration. Applicants are encouraged to use their technical ingenuity
and resourcefulness to develop more efficient and less costly methods of achieving the objectives of
Part 27. Regulatory personnel and designees should respond to such efforts by the use of
engineering judgment in fostering any such efforts as long as the letter and spirit of Part 27 and the
Federal Aviation Act are respected. It is recommended that unusual or unique projects be
coordinated a sufficient time in advance with the Rotorcraft Standards Staff, ASW-110, or with the
appropriate airworthiness authority, to ensure timely and uniform consideration.
6. APPLICABILITY. This material is not to be construed as having any legally binding status and
must be treated as advisory only. However, to ensure standardization in the certification process,
these procedures should be considered during all rotorcraft type certification and supplemental type
certification activities.
7. PARAGRAPHS KEYED TO FAR PART 27. Each paragraph has the applicable amendment to
Part 27 shown in the title. All of the original guidance material has been retained as appropriate,
even as changes are made to the regulations. This is accomplished through the use of “A,” “B,” etc.,
paragraphs that follow the original numbered paragraphs. These subsequent paragraphs provide
updated guidance information or changes to policy that parallel a specific rule change. The guidance
material in the original paragraph (for earlier amendments) still applies and is modified as explained in
each of the later paragraphs for later amendments. The applicable amendment number will only
appear in the title line for the “A,” “B,” etc., paragraphs. The guidance material in the initial paragraph
is intended to apply to all amendments except as modified by the later paragraphs. Each ensuing
“A,” “B,” etc., paragraph will be identified with an amendment level to indicate the rule change that
precipitated the policy change.
Page ii