Certification of Normal Category Rotorcraft — Changes 1–9
Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.
This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
2/4/2016 AC 27-1B, Chg 7
Note: Not all ATA chapters or subchapters have been included. Also, the italicized entries are not usually included in the
failure condition description but in the systems description or assumptions section.
ATA 26-00-00 - FIRE PROTECTION
Failure Phase of Effect of the Failure on Classification Notes Supporting Verification Function ATA Condition Operation the Aircraft, Crew and of the FC (assumptions) Material Method Description (FC) Occupants
Provide Inability to A substantial reduction in Analysis,
smoke detect smoke ALL safety margins would Gnd Test
detection in in the exist due to the delay in
baggage baggage the pilot’s reaction to take
compart compart immediate action.
ment ment.
The aircrew workload
would increase
significantly due to
handling emergency
procedures.
Occupants could succumb
to smoke inhalation.
26-12 Fire
Detection
Provide fire Unannunci- A substantial reduction in Analysis
detection of ated loss of ALL safety margins would and/or Flt
engine fire fire detection exist due to the latency of Test
zone. in the engine the failure increasing the
compartment risk of an actual fire going
(single and undetected.
dual engine).
Aircrew workload would
not be affected.
Figure AC 27 MG 21-1. Generic Examples by ATA.
Page MG 21 - 21
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Start with the certification basis and the function.
Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.
1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.